User Manual

Installation and Programming GMH Series VHF Radio
Page 2-4 BK RADIO
7. Press the
[ENT]
key to store the new password and
proceed to programming mode. The display will
change to
PRG Ch 000
.
2.2.2 General Performance Variables (Channel 0)
Channel 0 settings for each group must be programmed separately. Select the group to be
programmed (if applicable) by pressing the GRP button an rotating the Channel Select knob. Press
the GRP button again to return toe Channel Select mode.
The same password is used for all groups in the radio.
NOTE: Settings listed as Group One functions, Group Two functions, and Group Three functions
refer to programming function groups, not channel groups.
Press the
[FCN]
key on the keyboard repeatedly to view the settings in Channel 0, then loop back to
the
CH 000
entry point. Channel 0 settings include:
Automatic Number Identification (ANI)
Transmitter Timeout Timer
Scan Delay Time
Group One functions: 1-12345
Priority Scan Operation
Priority Key Lockout
Scan List Lockout
Group Two functions: 2-12345
Enable User Code Guard
Busy Channel Operation
ANI Enable
DTMF Enable
Group Label
2.2.2.1 Automatic Number Identification (ANI)
1. After entering the programming mode the display will
show
PRG Ch 000
.
2. Press the
[FCN]
key.
3. The display will indicate the ANI ID number (as many
as seven digits may be used). The ID number can
be used for either radio management or transmitted
as a DTMF tone burst for ANI purposes. The ANI
can be enabled or disabled. See “ANI Enable” on
page 2-8.
4a. If no change is needed for the ID number, press the
[FCN]
key to advance to the next section.
4b. A new number can be entered by pressing the
[CLR]
key, followed by number keys. The digits will
appear at the right of display and move to the left.