User Manual

GMH Series VHF Radio Installation and Programming
BK RADIO Page 2-9
2.2.4.3 ANI Enable
When function 4 is enabled (flashing) the ANI ID
number will be transmitted (as a DTMF tone
sequence) with each press of the PTT switch. See
"Automatic Number Identification (ANI)N on page 2-
4 for instructions on setting the ANI number.
When functions 4 and 5 are both enabled (flashing)
the ANI tone sequence will be transmitted only after
the [ENT] key is pressed while the transmit PTT
switch is activated. A sidetone of the ANI number
transmitted will also be heard through the speaker.
2.2.4.4 DTMF Enable
When function 5 is enabled (flashing) the
microphone keyboard becomes active for manual
DTMF operation.
2.2.4.5 Store Group Two Settings
Once Group Two functions are set, press the
[ENT]
key to store them into memory and
automatically advance the program to the next section.
Once each function 1-5 is set as desired, you can store the changes, discard the changes, or
disable all 5 functions.
Press the
[CLR]
key to disable all Group Two functions (steady).
Press the [
ENT]
key to store new Group Two settings into memory and advance to the next
section.
Press the
[FCN]
key to advance to the next section without saving changes.