User's Manual
Table Of Contents
- Introduction
- FCC Requirements
- Industry Canada Compliance
- Information and Options
- Radio Controls
- LCD Touch Screen
- Microphone Controls
- Function Selection
- Channel/Zone Selection Options
- Basic Operation
- Trunking Channel Basic Operation
- Command Zone Operation
- Code Guard/NAC Operation
- Mixed Mode Operation
- Scan Options
- Encryption Operation
- User Pick List Options
- Emergency Signaling
- Messaging Options
- Paging and Call Alert
- Other Functions & Options
- Backlight [LITE]
- Cloning
- Control Lockout [LOCK]
- Date and Time [DATE]
- Global Positioning [GPS]
- Hard Power Down [PWRD]
- Home [HOME]
- Inhibit/Uninhibit [INH]/UINH]
- Keypad Programming
- Minimum Volume [VOL]
- Monitor [MON]
- Nuisance Channel Delete [NUIS]
- Phone [PHN] and Hang Up [HANG]
- Radio Accountability Tone [RAT]
- Radio Info
- Repeater Talkaround [T/A]
- Send Alert Tone [SNDT]
- Send Signal [SEND]
- Squelch Adjust [SQL]
- Site Display [STDS]
- Site Lock [STLK]
- Site Search [STSR]
- Surveillance Mode [SURV]
- Transmit Digital [TXD]
- Transmit Power [PWR]
- Two-Tone Select [TONE]
- Versions
- Zone Select [ZONE]
- Keypad Programming Options
- 66 -
KNG Mobile Operation
NOTE: When sending a predened message the message ID is transmitted. The
receiving radio will display the message programmed with the corresponding ID.
If the receiving radio has no programmed message with the transmitted ID, “Text
Message X” is displayed, where “X” is the received ID number.
Manual Entry
When “Manual Entry” is selected use the microphone's keypad to enter the
desired message (see keypad character table). Press “Enter” to select the target
radio.
Select Target Radio
Last Call - Select “Last Call” to send the message to same radio you last sent a
text message. Press "SEND" to send the message.
Call List - Selecting “Call List” opens a list alias’ for pre-programmed Unit IDs.
Select the desired target radio and press “Send” to send the message.
Unit ID - Select “Unit ID” to enter the P25 ID of the target radio.
Use the keypad to enter the ID then press “Send” to send the message
Broadcast - Select “Broadcast” to send the text message to all text enabled
radios regardless of unit ID. Press “Send” to send the message.