User's Manual
Table Of Contents
- Introduction
- FCC Requirements
- Industry Canada Compliance
- Information and Options
- Radio Controls
- LCD Touch Screen
- Microphone Controls
- Function Selection
- Channel/Zone Selection Options
- Basic Operation
- Trunking Channel Basic Operation
- Command Zone Operation
- Code Guard/NAC Operation
- Mixed Mode Operation
- Scan Options
- Encryption Operation
- User Pick List Options
- Emergency Signaling
- Messaging Options
- Paging and Call Alert
- Other Functions & Options
- Backlight [LITE]
- Cloning
- Control Lockout [LOCK]
- Date and Time [DATE]
- Global Positioning [GPS]
- Hard Power Down [PWRD]
- Home [HOME]
- Inhibit/Uninhibit [INH]/UINH]
- Keypad Programming
- Minimum Volume [VOL]
- Monitor [MON]
- Nuisance Channel Delete [NUIS]
- Phone [PHN] and Hang Up [HANG]
- Radio Accountability Tone [RAT]
- Radio Info
- Repeater Talkaround [T/A]
- Send Alert Tone [SNDT]
- Send Signal [SEND]
- Squelch Adjust [SQL]
- Site Display [STDS]
- Site Lock [STLK]
- Site Search [STSR]
- Surveillance Mode [SURV]
- Transmit Digital [TXD]
- Transmit Power [PWR]
- Two-Tone Select [TONE]
- Versions
- Zone Select [ZONE]
- Keypad Programming Options
- 68 -
KNG Mobile Operation
Stored Messages
Up to ve messages can be programmed into the “Manual Entry List” and are
accessed from the “Select Entry Type” menu.
Short Message Update [MSG]
Conventional Digital Channels
Short Message Update is a way for the radio to transmit an enumeration that
corresponds to a predened message that is stored in other radios.
User Status Messaging [STS]
Conventional Digital Channels
Sending a Status Update
NOTE: When sending a message the message ID is transmitted. The receiving
radio will display the message programmed with the corresponding ID. If the
receiving radio has no programmed message with the transmitted ID “Status:
Status X” is displayed, where “X” is the received ID number.
Select Status Message
Press the “STS” button or select “Status Update” from the menu.
From the “Select Status” menu, select the programmed message to send and
press “Enter”.