User's Manual
Table Of Contents
- Introduction
- FCC Requirements
- Industry Canada Compliance
- Safety Precautions
- Information and Options
- Battery Installation and Removal
- Battery Care and Maintenance
- Antenna Installation and Removal
- Radio Controls
- LCD Display
- Programmable Switch and Button Functions
- Channel/Zone Selection Options
- Basic Radio Operation
- Command Zone Operation
- Code Guard/NAC Operation
- Mixed Mode Operation
- Trunking Channel Basic Operation
- Scan Options
- Pick List Options
- Unit-to-Unit Call Options
- Emergency Signaling Options
- Encryption Operation
- Messaging
- Paging and Call Alert
- Radio Inhibit/Enable [INH]/[UNINH]
- Other Options and Functions
- Backlight [LITE]
- Battery Life [LIFE]
- Bluetooth [BT]
- Busy Channel Operation
- Channel Select [CHAN]
- Cloning [CLON]
- Contrast
- Control Lockout [LCK]
- Date and Time [DATE]
- Global Positioning [GPS]
- Hard Power Down [PWRD]
- Keypad Programming
- Minimum Volume [VOL]
- Monitor [MON]
- Nuisance Channel Delete [DEL]
- Phone [PHN] and Hang Up [HANG]
- Radio Accountability Tone [RAT]
- Radio info
- Repeater Talkaround [T/A]
- Send Alert Tone [SNDT]
- Send Signal [SEND]
- Squelch Adjust [SQL]
- Site Display [STDS]
- Site Lock [STLK]
- Site Search [STSR]
- Surveillance Mode [SURV]
- System Test
- Transmit Digital [TXAD]
- Transmit Power [PWR]
- Two-Tone Select [TONE]
- Versions
- Zone Select [ZONE] (Conventional and Trunked Channels)
- Keypad Programming
- Warranty
- My Radio Settings
RELM Wireless Corporation
- 6 -
When worn on the body, always place the radio in a BK Radio approved
clip, holder, holster, case, or body harness for this product. Using
approved body-worn accessories is important because the use of BK
Radio or other manufacturer’s non-approved accessories may result
in exposure levels which exceed the FCC’s occupational/controlled
environment RF exposure limits.
If you are not using a body-worn accessory and are not using the radio
in the intended use position in front of the face, then ensure the antenna
and the radio are kept at least one inch (2.5 cm) from the body when
transmitting. Keeping the radio at the proper distance is important
because RF exposures decrease with increasing distance from the
antenna.
Use only BK Radio approved supplied or replacement antennas,
batteries, and accessories. Use of non-BK Radio approved antennas,
batteries, and accessories may exceed the FCC RF exposure
guidelines.
For a list of BK Radio approved accessories visit the following website:
http://www.relm.com.
The AMBE® voice compression software included in this product
is protected by intellectual property rights including patent rights,
copyrights and trade secrets of Digital Voice Systems, Inc. The user
of this software is explicitly prohibited from attempting to decompile,
reverse engineer, or disassemble the object code, or in any other way
convert the object code into a human-readable form. This software is
licensed solely for use within this product. US Patent Nos. #6,912,495
B2, #5,870,405, #5,826,222, #5,754,974, #5,715,365, #5,701,390,
#5,649,050, #5,630,011, #5,581,656, #5,517,511, #5,491,772,
#5,247,579, #5,226,084, and #5,195,166.
Contact Information
For additional information on exposure requirements or other
information, visit website http://www.relm.com.