User's Manual
Table Of Contents
- Introduction
- FCC Requirements
- Industry Canada Compliance
- Safety Precautions
- Information and Options
- Battery Installation and Removal
- Battery Care and Maintenance
- Antenna Installation and Removal
- Radio Controls
- LCD Display
- Programmable Switch and Button Functions
- Channel/Zone Selection Options
- Basic Radio Operation
- Command Zone Operation
- Code Guard/NAC Operation
- Mixed Mode Operation
- Trunking Channel Basic Operation
- Scan Options
- Pick List Options
- Unit-to-Unit Call Options
- Emergency Signaling Options
- Encryption Operation
- Messaging
- Paging and Call Alert
- Radio Inhibit/Enable [INH]/[UNINH]
- Other Options and Functions
- Backlight [LITE]
- Battery Life [LIFE]
- Bluetooth [BT]
- Busy Channel Operation
- Channel Select [CHAN]
- Cloning [CLON]
- Contrast
- Control Lockout [LCK]
- Date and Time [DATE]
- Global Positioning [GPS]
- Hard Power Down [PWRD]
- Keypad Programming
- Minimum Volume [VOL]
- Monitor [MON]
- Nuisance Channel Delete [DEL]
- Phone [PHN] and Hang Up [HANG]
- Radio Accountability Tone [RAT]
- Radio info
- Repeater Talkaround [T/A]
- Send Alert Tone [SNDT]
- Send Signal [SEND]
- Squelch Adjust [SQL]
- Site Display [STDS]
- Site Lock [STLK]
- Site Search [STSR]
- Surveillance Mode [SURV]
- System Test
- Transmit Digital [TXAD]
- Transmit Power [PWR]
- Two-Tone Select [TONE]
- Versions
- Zone Select [ZONE] (Conventional and Trunked Channels)
- Keypad Programming
- Warranty
- My Radio Settings
KNG2 Portable Radio User’s Manual
- 25 -
Channel Scan List [SCN+]
Conventional Channels
The Channel Scan List allows the radio user to add or remove channels
from the list of channels to be monitored while channel scanning.
Channels designated as scan channels are identied by the symbol
at the top of the LCD display.
The Scan List operation can be assigned as a button or menu list item.
When Channel Scan List is assigned to a button, press the button to
add or remove the selected channel from the scan list.
If Vote Scan option is installed, pressing the "+/-" button will cycle the
scan setting for the selected channel through checked (for scan on),
"(V)" for Vote Scan, and O.
When assigned as a menu item, open the menu and select the channel
you wish to add or remove from the scan list. Press “+/-” to add or
remove. Channels in the scan list will be indicated with the symbol.
Talkback Scan
Conventional and Trunking Channels
If your radio is programmed for Talkback Scan, any PTT transmission
that occurs while a channel is active or while scan delay time remains,
will be on the transmit frequency of the received channel. The ‘RX’
indicator will be shown in the display while scan delay time remains.
Talkback Scan will not work if Priority Scan is on and your radio is also
programmed to transmit on the Priority 1 channel (see Priority Scan).
Vote Scan [Requires Option KZA0581]
Conventional Channels
Channels in a multicast conventional systems can be added to the scan
list and designated as “voted” channels. When a signal is received on
a voted channel the radio checks all voted channels in the vote scan
group and selects the channel with the best signal.
If enabled, vote scanning takes place whenever the channel scan
switch in on.
NOTE: Channel voting occurs only with Channel Scan and is disabled
when Zone Scanning. Channels programmed as Vote channels are
treated as normal scan list channels during Zone Scan operation.
Vote Scan groups can only be created in the PC Radio Editor.
See also Priority Scan and Zone Scan.