User's Manual
Table Of Contents
- Introduction
- FCC Requirements
- Industry Canada Compliance
- Safety Precautions
- Information and Options
- Battery Installation and Removal
- Battery Care and Maintenance
- Antenna Installation and Removal
- Radio Controls
- LCD Display
- Programmable Switch and Button Functions
- Channel/Zone Selection Options
- Basic Radio Operation
- Command Zone Operation
- Code Guard/NAC Operation
- Mixed Mode Operation
- Trunking Channel Basic Operation
- Scan Options
- Pick List Options
- Unit-to-Unit Call Options
- Emergency Signaling Options
- Encryption Operation
- Messaging
- Paging and Call Alert
- Radio Inhibit/Enable [INH]/[UNINH]
- Other Options and Functions
- Backlight [LITE]
- Battery Life [LIFE]
- Bluetooth [BT]
- Busy Channel Operation
- Channel Select [CHAN]
- Cloning [CLON]
- Contrast
- Control Lockout [LCK]
- Date and Time [DATE]
- Global Positioning [GPS]
- Hard Power Down [PWRD]
- Keypad Programming
- Minimum Volume [VOL]
- Monitor [MON]
- Nuisance Channel Delete [DEL]
- Phone [PHN] and Hang Up [HANG]
- Radio Accountability Tone [RAT]
- Radio info
- Repeater Talkaround [T/A]
- Send Alert Tone [SNDT]
- Send Signal [SEND]
- Squelch Adjust [SQL]
- Site Display [STDS]
- Site Lock [STLK]
- Site Search [STSR]
- Surveillance Mode [SURV]
- System Test
- Transmit Digital [TXAD]
- Transmit Power [PWR]
- Two-Tone Select [TONE]
- Versions
- Zone Select [ZONE] (Conventional and Trunked Channels)
- Keypad Programming
- Warranty
- My Radio Settings
RELM Wireless Corporation
- 56 -
User Password
Select “User Password” from the “Global” menu to edit the keypad
programming password. Enter a six-digit numeric.
NOTE: Changing the user password does not aect the power-up or
administrator password.
System Settings
To edit the programmable System settings, select “Keypad” from the
programing menu then select “System” from the sub-menu.
Select the item you wish to edit from the System menu.
System Priority 1 or 2 Channel
Priority channels can be assigned on a system wide basis. If
assigned, a system priority channel will be monitored during priority
scan regardless of the current operation zone priority channel.
When set to “O”, the Priority 1 or Priority 2 Channel is designated by
the selected zone setting.
When set to “Use Main” the channel selected by the channel knob
operates as the priority channel.
To designate a specic priority channel choose “Select” from the
priority channel menu.
Select the Zone and Channel.
Tx on Priority 1 Channel
If on, the radio will transmit on the System Priority 1 channel
whenever Priority Scan is on.
Zone Settings
To edit the programmable Zone settings, select “Keypad” from the
programing menu then select “Zone” from the sub-menu.
Select Add, Delete or Edit Zone from the Zone menu.
Add Zone
When selected, a new zone is added in the next available slot.
Example: If there are seven zones in the radio, the added zone will be
zone eight.