User's Manual

30
KNG User’s Manual
31
RELM/BK Radio
Button Operation
High - Press the programmed button.
LPW
Low - Press the button again. LPW
Menu Operation
Press the assigned Menu button.1.
Use the up/down buttons to select 'TX Power'.2.
Press the 'ENT' button.3.
Use the up/down buttons to select High or Low.4.
Press the 'ENT' button to set the selection.5.
Hold the 'ESC' button to return to normal operation.6.
Zone Select (ZON)
Ch 1
KNG-P150 P25
Zone Label
LIGT T/A MENU SQL
TXD
KNG-P150 P25
Zn 12 : Ch 15
LIGT T/A MENU SQL
TXD
The 512 channels available in the KNG can
be divided into multiple operating zones.
Switching between zones is acomlpished via
a programmed button or menu item. Optionally,
zone labels or numbers can be displayed on
the LCD. (See Alphanumeric Label Options.)
Channel Scan
Zone Select
PRI Scan
ESC ▲ ▼ ENT
TXD
Zone Select
Zone #
ZONE LABEL
ESC ▲ ▼ ENT
Button Operation
Press the programmed button. 1. ZON
Use the up/down buttons to select the 2.
desired zone.
Press 'ENT' to set the zone.3.
Press the 'ESC' button to return to normal 4.
operation.
Menu Operation
Press the assigned Menu button.1.
Use the up/down buttons to select the 2.
desired zone.
Press 'ENT' to set the zone.3.
Hold the 'ESC' button to return to normal 4.
operation.
Scan Operation Options
Channel Scan (SCAN)
Ch 1
KNG-P150 P25
171.58500 MHz
LIGT T/A MENU LCK
Ch 1
KNG-P150 P25
171.58500 MHz
LIGT T/A MENU LCK
RXD SCN
SCN
The display indicates scan operation by
ß ashing SCAN.
Scan operates only while the radio is not
transmitting. The radio checks for signals on
channels in the preset Scan List, as well as
the channel selected by the Channel Selector
knob.
When a signal is detected, scanning stops
and the message is received. The received
channel is shown in place of the selected channel.
Once the signal ends, the radio continues to monitor the channel for
the preset scan delay time before it resumes scanning.
Toggle switch operation
On - Slide the programmed switch toward the front of the radio.
Off - Slide the switch up toward the channel select switch.
Zone Select
Channel Scan
PRI Scan
ESC ▲ ▼ ENT
TXD
Channel Scan
→
Off
On
ESC ▲ ▼ ENT
Button Operation
On - Press the programmed button.
SCAN
Off - Press the button again. SCAN
Menu Operation
Press the assigned Menu button.1.
Use the up/down buttons to select 2.
'Scan'.
Press the ENT button.3.
Use the up/down buttons to select 'On' 4.
of 'Off'.
Press the 'ENT' button to set the 5.
selection.
Hold the 'ESC' button to return to normal 6.
operation.
Scanning Code Guarded Channels
When a signal is detected, scanning stops while the radio checks for
the proper Channel Guard value. If the signal contains the proper
Channel Guard value, the radio receives the message. Otherwise, the
radio resumes scanning immediately.