Operation Manual

e) FX/Reverse function -21 H / S-
Firstly push the FX/Reverse button -21 H / S- in order to enable this mode. There
are three possibilities at your disposal.
• Reverse effect:
If “Reverse” has been selected in the drop down menu you can activate the
reverse play mode by by using the FX/Reverse button
-21 H / S-.
• Effect 1 function:
If effect 1 has been selected in the drop down menu the effect from the effect
section -29 S- will be enabled. By using the jog wheel -18 H / S- you can now
modulate an the selected effect's parameter.
NOTE!
By pushing and holding the shift button -23 H- and turning the jog wheel
-18 H / S- at the same time you can modulate the second parameter.
• Effect 2 function:
see item b)
Please refer to the next chapter 3.8. “Effect Section” for further details.
3.8. Effect section
Your Reloop Attack software disposes of 8 high-quality effects. It is possible to
enable two effects per player.
NOTE!
It is possible to combine two different effects per player.
Via the buttons -29 H / S- you can (de-)activate the respective effect. The
selected effect is displayed in the drop down menu below the activating buttons.
You can select another effect via the mouse. In order to change with your
controller push and hold the shift button -23 H- and push the effect 1 or effect 2
button -29 H-. This way you can change the effects. Two parameters per effect
are adjustable. The following effects are at your disposal:
45
ENGLISH
Effect name: Parameter Time: Parameter Ratio:
1. Delay 0 – 9.999 delay gap length 0 – 255 delay gain
2. Skid 100 – 9.999 stop time 100 – 9.999 start time
3. Filter 0 – 9.999 auto scan period 0 – 255 filter frequency
4. Phase 1 – 9.999 play rate 0 – 255 sweep depth length
5. Flanger 1 – 9.999 waveform cycle 0 – 255 mix depth
6. Echo 0 – 9.999 echo gap 0 – 255 echo gain
7. Trans 30 – 9.999 trans X parameter 0 – 255 trans Y parameter
8. Pan 0 – 9.999 pan cycle 0 – 255 pan gain