Operation Manual
T26
Regulates the respective channel‘s volume.
T27
The dial adjusts the master output‘s volume.
T28
The dial adjusts the headphones‘ volume.
T29
With the Cue Mix Fader it is possible to simu-
late a pre-mix via the headphones. In the right
position the master signal is audible, in the left
position the cue signal is audible.
T30
Illuminated when the controller is turned on, if
voltage is provided.
T31
Illuminated when MIDI signals are sent.
T32
Optically displays the master output level.
T33
Crossfader between ch.1 and ch.2
There are a few settings and tests which can be carried out directly with Mixage without the need
for a computer. In the following a few points will be explained more thoroughly.
It is possible to connect a further Mixage controller, i.e. for DJ teams. For this purpose it is important
that one Mixage is on MIDI channel 1 and the second Mixage is on MIDI channel 2 (see switch -B40-).
Reloop‘s ofcial mappings are laid-out according to the standard conguration. Therefore changes
are usually unnecessary.
Herewith it is possible to check whether all of Mixage‘s LEDs work properly.
To carry out the functional test proceed as follows:
1. Make sure that Mixage is turned off (USB cable has to be disconnected -B39-).
2. Press and hold the left Sync Button -T16- and turn on Mixage by connecting the USB cable -B39-.
3. Now release the Sync Button -T16-.
4. Now all LEDs should be illuminated.
5. In order to nish the test, simply turn off the device by disconnecting the USB cable -B39-.