User Manual
This is suggestive if you would like to link several RMP-2.5 Alpha players on one computer. This
way each player will be displayed with an individual hardware ID. Please also see the chapter “Lin-
king several RMP-2.5 Alpha Players”.
You can determine whether MIDI parameters should be displayed or not. To do so hold the Shift
Button -32- and turn the Track Encoder -4- in order to switch between “Display” and “Hide”.
In the MIDI CC Type menu you can assign individual Control & Change parameters to the Tack En-
coder -4-, Pitchfader -22- and Jog Wheel -18-.
In order to change the CC Type hold the Shift Button -32- and turn the Track Encoder -4- to the
desired position.
• Track (Track Encoder)
The following is possible:
Relative
Absolute
Note
• Jog (Jog Wheel)
The following is possible:
Relative
Note
With this option you can determine on which MIDI channels the RMP-2.5 Alpha should send data
and which Traktor decks should be controlled.
The following presets are available:
A-D = 1-4
In this preset you can seamlessly switch from “DeckA CH01” to “DeckD CH04” by pressing the
Bank P. Button.
This preset is recommendable to either use an RMP-2.5 Alpha to control four Traktor decks or to
link up four RMP-2.5 Alpha players.
A/C = 1/3
With this preset you can switch back and forth between “DeckA CH01” and “DeckC CH03”.
This preset is reasonable if you have two RMP-2.5 Alpha players and you would like to use one
player for Deck A/C and the other one for Deck B/D.
B/D = 2/4
With this preset you can switch back and forth between “DeckB CH02” and “DeckD CH04”. This
preset is reasonable if you have two RMP-2.5 Alpha players and you would like to use one player
for Deck A/C and the other one for Deck B/D.
Please also see the paragraph „Linking several RMP-2.5 Alpha Players“.
In this menu you can edit the single MIDI elements and parameters.
Please also refer to the MIDI map in this manual.
In order to change a parameter hold the Shift Button -32- and adjust the desired value via the
Track Encoder -4-.
Example:
You would like to assign a different MIDI command to the Bank Program Button -09-. In the MIDI
map you can see that Tap is assigned to MIDI command 09. In the MIDI Note Edit menu select po-
sition 09. Now hold the Shift Button -32- and set the desired new MIDI value by turning the Track
Encoder -4-.