Operation Manual

ENGLISH
64
1.6 INTERFACE CONTROLLER
With your Spin! 2+ Interface it is possible to directly control the most important software functions
without having to use the mouse. The control elements will be explained in detail below.
a) Track Browsing & Beat Match
By turning the Trax Encoder -29- you can navigate through the Spin! Library. By pushing the Load
Buttons -28- you can load a track to the corresponding player. If desired you can synchronise a
track with the opposing one at the push of a button by using the Match Buttons -27-.
b) Cue & Loop Section
By pushing the Shift Button -33- and the Cue / Set Button -32- you can set a cue point. In order
to call up the last set cue point push the Cue / Set Button -32-.
Push the Loop button -24- in order to set an automatic beat loop. Via the +/- buttons -25/26-
you can adjust the bar length. By pushing the Loop Button -24- again you leave the beat loop. In
order to set a manual looppush the Shift Button -33- and the In Button -25- for the Loop In Point
and Shift -33- and the Out Button -26- for the Loop Out Point. You can leave the manual loop by
pushing the Shift Button -33- and the Exit Button -24-.
c) Effect & Mode Section
Via the effect knobs FX 1-3 -21, 22, 23- you can adjust the three master effects. In order to change
the Spin! Mode hold the Shift Button -33- and turn the Spin! Mode Knob -21-. You can change the
Pitch Mode by holding Shift -33- and turning the Pitch Mode Knob -22-.
Activate the Reloop Function by holding the Shift Button -33- and turning the Reloop Knob -23-.
NOTE!
Visit www.reloop-spin.com regularly for video tutorials and updates.
2. SOFTWARE GENERAL SURVEY
1
22
51
47
45b
50
52
40 53
3 5 7 9 11 13 15 17 19
2 4 6 8 10 12 14 16 18 20 21 24 25
46
54 54
29
30
31
39
38 32
36 35 34
37 33
27 26
41 42 43 44
45a
28
23