User's Manual

User Manual version 3.2
Move series radiocontrols mod. GENESIS, PAIL, BRICK and T April 2016
REM device ® - ITALY 3
DESCRIPTION
The move radio control system consists of one or more transmitter units:
GENESIS move BRICK move
PAIL move T 3,5,7 move
and of one or more receiver units:
RUBYBOX move ECOBOX move DIN move
User Manual version 3.2
Move series radiocontrols mod. GENESIS, PAIL, BRICK and T April 2016
4 REM device ® - ITALY
How TO USE the DEVICE CORRECTLY and SAFELY
The remote control has been designed strictly for use by qualified
operators only, who are required to first read the instructions on how to
use the device and comply with the safety standards prescribed by the law
in the area where work is carried out.
REMdevice shall not be liable for any bodily injury or damage to property
resulting from:
• misuse or inexpert use of the device
• incorrect wiring or electrical connections
• tampering
• changes to the radiocontrol's design features
• replacement of parts with non-original spare parts
• failure to perform maintenance
• failure to replace worn, faulty or defective parts
• the device being used with its intrinsic safety features disabled or
its original features altered in any way.
Warning: This device works using radio signals; it can operate the
machinery it is connected to even if barriers are blocking its line of sight,
such as brick walls, metal or wooden panels, other machinery, equipment,
buildings, vehicles; it is important operators exercise the utmost care when
activating the controls in order to avoid uncontrolled movements.
Activating the radiocontrol
• Stand with the transmitter unit so that there is a perfectly clear
full line of sight between it and the machinery
• do not linger under overhead loads
• do not operate from an unstable position
• take proper note of the control's identification plates located next
to each button or actuator
• do not press any button or actuator if you do not know exactly
what it does
Transmitter units
Transmitter units are made so as to comply with the control functions of
the machine they control. The figures shown are generic.
For your model, please refer to the datasheet attached to this manual.