Instructions / Assembly

ManualsBrandsRemington Solar ManualsGarden Center6 in. 30-Watt Solar-Powered Dual Foundation Crawl Space Fan

1 | P a g e

Message from our president…

Congratulations! You’re in the club. You’ve seen the light. You own the best solar attic fan sold in the United

States. While we look forward to cooling your attic, thus saving you on utility bills, there are other advantages

to the Remington Solar attic fan as well. Do you have any idea how much wear and tear on your furnace

happens in a hot harsh environment? Do you know what your expensive insulation does in 150 degree heat

over the years? You made a great decision in your purchase, so please don’t hesitate to contact us if you need

help in any way.

Murray Smith

President – Remington Solar

214-257-8300

Model # SF20

Roof mount

Model # SGF20

Gable mount

Model #SF25

Roof mount

Model #SF-30

Roof mount

Tools Required

Reciprocating Saw Marking Pen

Measuring Tape String

Razor Knife Drill (for screws)

Caulking Gun (Silicone sealant)

6, 6# 1½ Phillips Head Screwdriver

NOTE: Please go to

http://remingtonsolar.com/how-to-

install-your-remington-solar-attic-

fan/ (or go to RemingtonSolar.com

and look for the link How To Install

Your Remington Solar Attic Fan) to

watch a brief video of an actual

installation.

30 Watt Foundation Fan

Summary of content (6 pages)

PAGE 1
Message from our president… Congratulations! You’re in the club. You’ve seen the light. You own the best solar attic fan sold in the United States. While we look forward to cooling your attic, thus saving you on utility bills, there are other advantages to the Remington Solar attic fan as well.
PAGE 2
Each model is a bit different SF20 – This is a simple encased panel fan that flashes underneath the leading edge of your shingles. This unit includes humidistat and thermostat. Make sure you remove the small plastic bag that has the small thermostat and humidistat (underneath the fan near the blade) after installation. Also, clip the small plastic tie that will allow the thermostat to hang (approximately 2 feet) from the unit (to get an accurate attic temperature reading).
PAGE 3
4. If it is cool outside and you want to test your fan, you may cup the thermostat in your hand and breathe heavily on it. That will typically kick on the fan. Handy Tips 1. Choose the location carefully to ensure optimal sun exposure through the day. Check for any shade on the roof created by trees, chimney, or satellite dish. 2. Measure twice and cut once. Take a minute to create a template that will create the correct dimensions for your cut. 3.
PAGE 4
Slide the flashing underneath the tar paper and shingles. Adjust the flashing up until the shingles come into contact with the raised portion of the flashing. The bottom side of the flashing will be on top of the shingles. Step 7 Position the four screws around the flashing. Two screws go on either side, and the remaining two go on the top and bottom.
PAGE 5
WARRANTY Solar panel Life time limited warranty* Housing: Life time limited warranty* Motor : Life time limited warranty* *The limited warranty from date of original purchase for manufacturing defects under normal and reasonable use, and subject to the maintenance requirements and installation guidelines set forth in the product instruction manual. This warranty is non-transferable. You must register your warranty online within 30 days from purchase.
PAGE 6
support@remingtonsolar.com for replacement. Foundation Fan SF30-FND The SF30-FND solar powered foundation ventilation fan is easily mounted from the inside with the plate mounted directly onto the foundation wall surface. You will need concrete anchor screws or bolts. Put the SF30-FND against the wall and mark with a felt pen exactly where to drill. Drill into the concrete or brick using a masonry drill bit. Then put the anchor sleeve into the hole.