Instructions / Assembly

6 | P a g e
[e-mail] for replacement.
Foundation Fan SF30-FND
The SF30-FND solar powered foundation ventilation fan is easily
mounted from the inside with the plate mounted directly onto the
foundation wall surface. You will need concrete anchor screws or
bolts. Put the SF30-FND against the wall and mark with a felt pen
exactly where to drill. Drill into the concrete or brick using a masonry
drill bit. Then put the anchor sleeve into the hole. Place the fan plate
against the wall, then screw in with anchor bolts or screws.
The fan comes with 30 feet of cord to the solar panel. Remove the
plastic cover from the terminal box. (It simply pops off.) Remove the
power wires (black and red) from each terminal using a phillips head screwdriver and thread them out the
hole on the fan mounting plate. Secure wiring outside as you find a sunny place for the solar panel. You
may use the mounting bracket by screwing directly down to your roof. Use roofing caulk to seal the screw
to prevent water leak. Then adjust the angle
to maximize sun angle. (Typically that would
be flat to the earth or slightly angled towards
southwest.)
If your roof angle is optimal to the sun, you
may just want to mount your fan flat on your
roof. If you have a fence or other stable
structure that is in the sun, you may also
mount to that.