Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty Operator’s Manual 3-in-1 Battery Mower WARNING READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE. FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY. MTD LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019 Form No.
1 To The Owner Thank You Thank you for purchasing an Electric Mower manufactured by MTD LLC. It was carefully engineered to provide excellent performance when properly operated and maintained. Please read this entire manual prior to operating the equipment. It instructs you how to safely and easily set up, operate and maintain your machine. Please be sure that you, and any other persons who will operate the machine, carefully follow the recommended safety practices at all times.
Important Safe Operation Practices 2 WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol. HEED ITS WARNING! DANGER: This machine was built to be operated according to the rules for safe operation in this manual.
12. Never pull the mower back toward you while you are walking. If you must back the mower away from a wall or obstruction first look down and behind to avoid tripping and then follow these steps: a. Step back from mower to fully extend your arms. b. Be sure you are well balanced with sure footing. c. Pull the mower back slowly, no more than half way toward you. d. Repeat these steps as needed. Slopes are a major factor related to slip and fall accidents which can result in severe injury.
10. Maintain your mower with care — Keep mower blade sharp and clean for best and safest performance. Mower blades are sharp and can cut, wrap the blade or wear gloves and use extra caution when servicing them. 11. Keep all nuts, bolts, and screws tight to be sure the equipment is in safe working condition. 12. Never tamper with safety devices. Check their proper operation regularly. 13. Never attempt to make wheel or cutting height adjustments while the motor is running. 14.
Safety Symbols This page depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate. Symbol Description READ THE OPERATOR’S MANUAL(S) Read, understand, and follow all instructions in the manual(s) before attempting to assemble and operate DANGER — ROTATING BLADES To reduce the risk of injury, keep hands and feet away.
dot e) a 1 5 ° slop or a fence post nts ted lin e( r e p r ese or a corner of a building... old al ong F Sight and hold this level with a vertical tree... 15° Use this page as a guide to determine slopes where you may not operate safely. WARNING: Do not operate your lawn mower on such slopes. Do not mow on inclines with a slope in excess of 15 degrees (a rise of approximately 2-1/2 feet every 10 feet). A riding mower could overturn and cause serious injury.
3 Assembly & Set-Up Contents of Carton • One Battery Mower • One Side Discharge Chute • Two Cord Guides • One Operator’s Manual • Two Toggle Clamps • One Battery • One Charger • One Grass Bag NOTE: All references to the left and right side of the mower are from the operator’s position behind the mower. Unpacking the Unit 1. Cut the corners of the carton and lay the sides flat on the ground. Remove all packing inserts. Handle Assembly 1.
5. Place the upper handle onto the lower handle, keeping the motor cord over the handles. See Fig. 3-3. a. For the lowest setting, line up the top holes of the upper handle with the holes on the lower handle. b. For the medium setting, line up the middle holes of the upper handle with the holes on the lower handle. c. For the highest setting, line up the bottom holes of the upper handle with the holes on the lower handle. 5. Tighten the clamps. See Fig. 3-4.
Grass Collection 1. c. To assemble the grass catcher, secure the plastic channels of grass bag over frame rods. See Fig. 3-6. Figure 3-6 2. Follow steps below to attach grass catcher: a. Lift rear discharge door. b. Remove rear mulching baffle. See Fig. 3-7. Place grass catcher on the pivot rod. Let go of discharge door so that it rests on the grass catcher. See Fig. 3-8. Figure 3-8 To remove grass catcher, lift rear discharge door on the mower.
3. Secure the tabs of the side discharge chute onto the hooks below the side mulching baffle. See Fig. 3-9. NOTE: Do not remove side mulch baffle at any time, even when you are not mulching. Mulching To mulch, you will need the rear mulching baffle installed below the rear discharge door. If converting to mulching from the grass collection mode: 1. Remove grass catcher. 2. Install rear mulching baffle. See Fig. 3-10.
4 Controls and Features Starter Button Motor/Blade Control Lever Battery Level Indicator Overload Protection Switch Safety Key Cutting Height Adjustment Lever Figure 4-1 Warning: Read, understand, and follow all instructions and warnings on the machine and in this manual before operating. Motor/Blade Control Lever Warning: The motor/blade control lever is a safety device. Never attempt to bypass its operations. The motor/blade control lever is located on the upper handle of the mower.
5 Operation Starting Motor and Blade 3. Press the starter button and hold it in. See Fig. 5-2. NOTE: Starting the mower’s motor also engages the blade. WARNING: Avoid accidental starting. Make sure you are in the operating position behind the mower when using it. To avoid serious injury, the operator and unit should be in a stable position while starting. 1. Insert safety key. Refer to Fig. 5-1. Figure 5-2 4.
Using Your Lawn Mower Removing the Battery Be sure that lawn is clear of stones, sticks, wires, or other objects which could damage the lawn mower or motor. Such objects could be accidentally thrown by the mower in any direction and cause serious personal injury to the operator and others. If you have two batteries, you can use one battery while the other battery recharges. To remove the battery: WARNING: If you strike a foreign object, stop the motor, and remove the key.
General Recommendations Deck Care • Always observe safety rules when performing any maintenance. WARNING: To reduce the risk of electric shock, do not expose the mower to water. • The warranty on this lawn mower does not cover items that have been subjected to operator abuse or negligence. To receive full value from warranty, operator must maintain the lawn mower as instructed here.
If the overload protection switch pops out shortly after resetting: Battery Care 1. Release the motor/blade control handle and do NOT restart the mower for at least 15 minutes to allow the electric motor extra time to cool. IMPORTANT: Replace with only the identical batteries provided with this mower. The batteries should only be replaced by an authorized service dealer. 2. Press the overload protection switch inward to reset. 3. Restart unit.
7 Service Blade Care Blade Installation WARNING: When removing the cutting blade for 1. sharpening or replacement, protect your hands with a pair of heavy gloves or use a heavy rag to hold the blade. Be certain to disconnect the power supply. Periodically inspect the blade assembly for cracks, especially if you strike a foreign object. Replace when necessary. Follow the steps below for blade service. 1. Stop the motor and remove the safety key from the battery. 2.
Off-Season Storage The following steps should be taken to prepare your lawn mower for storage. • Clean and lubricate mower thoroughly as described in the lubrication instructions. • We do not recommend the use of a pressure washer or garden hose to clean your unit. • Coat mower’s cutting blade with chassis grease to prevent rusting. • Store mower in a dry, clean area. Do not store next to corrosive materials, such as fertilizer.
8 Troubleshooting Problem Mower fails to start Mower stops while mowing Mower cutting grass unevenly Mower not mulching properly Hard to push Mower vibrating at higher speed Cause Remedy 1. Key not in switch. 1. Insert Ignition key. 2. Motor/blade control disengaged. 2. Depress starter button, and engage motor blade control. 3. Battery discharged. 3. Charge battery. 4. Mower deck clogged with grass and debris. 4. Unclog mower deck. Make certain blade is free to move. 1.
Model 18A-212B 78 41 86 83 56 57 46 4845 62 69 68 47 43 83 70 66 44 67 5049 52 53 51 13 14 82 71 54 16 39 55 38 84 74 75 73 30 17 18 72 61 12 5 63 64 31 15 58 77 65 9 42 10 59 60 2 40 1 87 89 20 85 11 29 21 27 19 34 22 32 88 33 25 28 26 3 4 35 36 37 24 8180 8 23 79 6 7 For a new battery pack, order part 725-05089.
Model 18A-212B Ref. 1 Part Number 787-01839A Description Ref.
Notes 22 10
Section 10 — Notes 23
MANUFACTURER’S LIMITED WARRANTY FOR IMPORTANT: To obtain warranty coverage owner must present an original proof of purchase and applicable maintenance records to the servicing dealer. Please see the operator’s manual for information on required maintenance and service intervals.
