Manual

13
Instructions For Assembly Of Shotgun (cont’d)
2. Now push the top lever of the receiver to the right and hold with one hand. Do not force the top lever.
(See
Picture 23).
3. Holding the barrels with the other hand, engage the lower locking lug located on the lower portion of
the barrel with the receiver. The half round cut out on the lower locking lug fits around the round bar in
the forward lower portion of the slot in the receiver. With the barrels engaged into the receiver, swing the
barrels up into the locked position. The top lever should move back to the center once the barrels are
locked into position. Note: The top lever may not move completely to the center on a new shotgun until
the gun is broken in. The top lever must move at least three quarters of its full travel distance.
(See
Pictures 24, 25 and 26).
4. Now that the barrels have been locked into the receiver, you must reattach the fore end to the barrel. Place
the fore end on the front curve of the receiver (the angle between the fore end and barrels should be about
20 degrees). Keeping the contact between fore end and receiver with an upward swing motion, lock the
fore end into the barrels. While it may be necessary to push the latch into its final flat position, never force
the latch into position. (See
Picture 27).
12
Picture 23
Picture 27
Picture 24 Picture 25
Picture 26