Manual

11
To Adjust the Sights
TO ADJUST THE REAR SIGHT :
For elevation (up and down adjustments) and windage
(left and right adjustments), move the rear sight in the
same direction as you need to move the bullet on the
target. See Picture 12.
NOTE: For more information on ballistics and trajectory, see the
REMINGTON
®
catalog.
TELESCOPIC SIGHTS:
The top of the receiver has holes for the installation of telescopic sights.
Lubrication and Maintenance
NOTE: The chamber should be cleaned before loading and firing the
firearm the first time. Follow cleaning instructions shown on page 12.
Over-lubrication should be avoided at all times. A thin
coat of Rem™ Oil is needed to prevent the possibility of
rusting. See note below.
When the firearm is to be stored, it should be carefully
cleaned and thoroughly oiled. Outside surfaces should
be wiped with a light coat of Rem™ Oil occasionally.
When the firearm is to be reused, all excess lubrication must be
removed. The chamber and bore must be thoroughly wiped dry.
NOTE: Remington
®
Rem™ Oil is available from your local dealer. If your dealer
is out of stock, ask him to order Rem™ Oil from his Remington distributor.
TO CLEAN THE BARREL:
WARNING:
Check the chamber and magazine to make sure there are no cartridges in the firearm.
1. Use the instructions and the equipment provided in a good cleaning kit. For recommendations, see your
Remington Authorized Gunsmith.
2. Select the correct caliber cleaning brush and attach the brush to the cleaning rod.
3. Put the cleaning brush into the gun cleaning solvent.
4. Push the cleaning brush through the barrel several times.
NOTE: Always clean the barrel from the muzzle to the chamber.
5. Remove the brush from the rod. Attach tip with correct size cleaning patch and push through the bore.
6. Repeat several times using a new cleaning patch each time, until the patch is not dirty.
7. Push a clean patch saturated with Rem™ Oil through the barrel.
8. Push a clean, dry patch through the barrel to remove excess lubricant.
9. Apply a thin coat of Rem™ Oil to the outside of the barrel with a soft, clean cloth.
WARNING: After cleaning, make sure the barrel is free of obstructions.
All models with sights are
adjusted at the factory to hit
a target at 100 yards.
Rear Sight Aperture
Windage Screw
Rear Sight Slide
Elevation Screw
PICTURE 12