Manual

TO CLEAN THE CHAMBER:
Use the chamber brush that comes with the firearm.
WARNING: Check the chamber and magazine to make sure that there are
no cartridges in the firearm.
1. Engage the safety mechanism.
RED BAND WILL NOT SHOW.
2. Pull the operating handle rearward until held open by the magazine
follower.
3. Put the brush into the cleaning solvent.
4. Push the brush into the chamber through the ejection port. Repeat
several times. See Picture 13.
5. Using the rear of the cleaning brush with attached cleaning patch, dry
chamber. Repeat using a clean patch each time, until patch is not dirty.
WARNING: After cleaning, make sure the barrel is free of obstructions.
TO CLEAN THE ACTION SPRING AND ACTION TUBE:
WARNING:
Check the chamber and magazine to make sure there are no
cartridges in the firearm.
1. Loosen the fore-end screw and remove the fore-end. See Picture 14.
2. Brush action spring and action tube with gun cleaning solvent. See
Picture 15.
3. Dry with clean cloth.
4. Apply a thin coat of Rem™ Oil to prevent rusting.
5. Replace the fore-end and tighten fore-end screw.
TO CLEAN THE TRIGGER PLATE ASSEMBLY:
WARNING:
Make sure there are no cartridges in the magazine or chamber.
1. Engage the safety mechanism.
RED BAND WILL NOT SHOW.
2. Close the action.
3. Tap out front and rear trigger plate pins. See Picture 16.
4. Lift rear of the trigger plate assembly and remove the assembly
from the receiver.
NOTE: Clean trigger plate assembly as a unit with Rem™ Oil.
5. Spray the trigger plate assembly with Rem™ Oil as shown. See Picture
17. Let stand for 15 minutes. Spray again to wash off components. Shake
off excess lubricant.
WARNING: Excessive use of a non-recommended lubricant could
adversely affect the function and safe operation of your firearm.
6. Check to make sure that the end of the disconnector is below end of
left connector. See Picture 18.
7. Carefully insert the trigger plate assembly into the receiver.
8. Position to align holes and tap in front and rear trigger plate pins.
WARNING: This firearm should be checked periodically by the Remington
®
Arms Company, Inc. or a REMINGTON RECOMMENDED GUNSMITH. This
will ensure proper inspection and any necessary replacement of worn or
damaged parts.
12
PICTURE 13
PICTURE 14
PICTURE 15
PICTURE 18
PICTURE 17
PICTURE 16