Manual

4 I
3 lower/vat assembly
Assembling Blower
,_1. WARNING: To Reduce The
Risk of Personal injury or Electric
Shock- Disconnect from power
source before assembling or
changing attachments.
Follow the steps below to assemble the
blower. IMPORTANT;The blower will not
run unless the bottom inlet cover is locked
into place.
1. Slide the blower tube onto outlet on
front ofblower/vac housing (see Fig-
ure 3-1). Securely connect the draw
latch to the blower tube (see Figure
3-2).
2. Position front of bottom inlet cover
over motor housing hook (see Figure
3-3).
3. Pivot bottom inlet cover to bottom
of blower/vac housing. Slightly press
locking lever on bottom inlet cover
to allow cover to lock into place (see
Figures 3-4 and 3-5).
Figure3-1:Slidingblowertubeintoplace
Figure3-2:Connectdrawlatchto blowertube
Figure3-4:Pivotingbottominletcoverto blower/vac
housing
Figure3-5:Pressinglockinglever
®
Figure3-3:Attachingbottominletcoverto motorhousing
hook
120133