Operation Manual

GB
ENGLISH
13
Frequently Asked Questions
I have switched the unit ON, but I cannot increase or decrease the light intensity.
• Tryresettingtheunitbyturningitoandwaitingseveralsecondsbeforeturningitbackon.
The Bulb Status Indicator Light turns green but the unit does not flash when the button is pressed.
• MakesuretheSkinContactSensorisinfullcontactwiththeskin.
• Tryresettingtheunitbyturningitoandwaitingseveralsecondsbeforeturningitbackon.
There is a strange smell.
• Besuretheareaiscompletelyshavedbeforetreatment.
The treated areas become red after treatment.
• Thisisnormalandtherednessshouldsubside.Ifnot,tryusingalowerlightintensity.
I have not seen optimal results or hair has begun to grow back.
• Hairmaybegintogrowbackafteryourinitialtreatment.Thisisperfectlynormal.Foroptimalresults,
repeat the treatment when you notice hair regrowth.
Note:Donottreatthesameareamorethanonceaweek
BE AWARE: If the unit is used over an extended period of time, the unit might automatically disable
momentarily (estimated 40 seconds) to cool down. Once the unit has cooled down, it will be ready to use
again.
Intensity/Flash Mode LED Indication
AllcurrentlyselectedLEDsashing Unitisoverheatedandisdisabledmomentarilyto
cool down.
IntensityLEDsashinginsequence Unitismalfunctioning.Turntheunito,waitafew
moments and try again. If problem persists, the
unit should be returned for repair.
AllLEDsashingwithwarningbeep Noseconeisremovedorloose.
Audible Tones Indication
NotFullContact Flash button was pressed while the skin contact
sensor was not fully engaged.
ReplaceLightCartridge Light cartridge is missing or needs to be replaced.
ContactSensorsStuck Flash button was pressed after the contact sensor
hadbeenengagedsinceunitstartup.Contact
sensor may be stuck.
IPL6000_IB_BOOK_UK_ONLY.indd 13 1/12/11 14:55:50