Owner's Manual

Assembly Instructions) (cont’d)

TO ASSEMBLE:

1. Before assembling, clean the barrel assembly following the instructions on Pages 14 and 15.

2. Push the rear of the top lever to the right until it latches open. (See

Picture 5).

3. Remove fore-end from barrel assembly by pushing the fore-end latch rearward. (See

Picture 7).

4. Align the circular cuts on the

underside of the barrel

assembly with the pivot pins

in the front of the frame.

(See

Picture 8).

5. Hold the barrel assembly in

engagement with the pivot

pins and align the ejector cam

pins with their cam slot in the

frame. Then rotate the barrel

assembly until the top lever

latches into place in the center

of the frame top tang.

6. Carefully place the fore-end

assembly at a slight angle to

the barrel, and fit radius of the

fore-end iron to the matching

radius of the frame.

(See

Picture 9).

7. Push the fore-end assembly

against the bottom of the

barrel to latch the fore-end

assembly into place.

Picture 7

Picture 8

Pictur

e 9

CIRCULAR CUTS

PIVOT

EJECTOR

INS