Owner's Manual

Lubrication And Maintenance
WARNING! NEVER lubricate or clean your shotgun unless it is completely unloaded.
TO CLEAN THE BARREL ASSEMBLY:
1. Use the instructions and equipment in a good cleaning kit. For cleaning kit recommendations, see your
Remington
®
Authorized Service Center.
2. Select the correct gauge cleaning brush and attach the brush to the cleaning rod.
3. Put the cleaning brush into gun cleaning solvent.
4. With the action open, push the cleaning brush through the barrel several times.
5. Remove the brush from the rod, attach tip with cleaning patch and push through the bore.
6. Repeat several times, using a new clean patch each time until the patch is not dirty.
7. Remove all shooting residue from the locking lugs, ejectors and ejector sears. (See
Picture 14).
WARNING! After cleaning, always make sure that both barrels are free of obstructions.
TO CLEAN THE CHOKE TUBES:
1. Remove the choke tube from the barrel. (See instructions on PAGE 8).
2. Clean the choke tube including the threads with gun cleaning solvent and wipe dry.
3. Apply Rem™ Oil on the threads and reassemble the choke tube to the barrel following the instructions
on Page 9.
TO CLEAN THE INSIDE OF THE RECEIVER:
1. Brush the inside of the receiver with cleaning solvent and wipe dry. (See Picture 15).
14
Picture 14
Picture 15
E
JECTOR SEAR
L
OCKING L
UG
EJECTORS
FRONT
RADIUS
EJECTOR
CAM SLOTS
PIVOT PINS