Owner's Manual

Manufacturer’s Warning

This firearm was manufactured to properly perform with the original parts as designed. It is your duty to make

sure any parts you buy are correctly installed and that neither replacements nor originals are altered or changed.

Your shotgun has many parts that must relate correctly to other parts for safe and accurate operation. Putting a

gun together wrong or with modified parts can result in a damaged gun, or personal injury or death to you or

others. Always let a qualified gunsmith work on your gun or at least, check any work not performed

by a gunsmith. Firearms safety is your primary concern.

THE GUN OWNER MUST ACCEPT FULL

RESPONSIBILITY FOR THE CORRECT REASSEMBLY AND FUNCTIONING OF THE FIREARM AFTER

ANY DISASSEMBLY OR REPLACEMENT OF PARTS.

To Clean and Maintain The Exterior Of Your Shotgun

WARNING! Never lubricate or clean your shotgun unless it is completely unloaded.

1. All external surfaces should be wiped down with a light coat of rust preventative. Avoid using too much

oil as powder, dust or other foreign material may get trapped in the oil. This could lead to congealed

deposits which may interfere with the safe and reliable operation of this shotgun.

USE CAUTION while using solvents in gun cleaning. Prolonged or excess contact with

solvents can damage the gun’s bluing and finish. Be sure to wipe away all excess solvent and then

lubricate with oil.

WARNING

Lead or lead compounds are known to the State of California to cause cancer, birth defects, reproductive toxicity, and other

serious physical injury. Those who clean firearms should take protective measures to avoid contact or exposure to such

chemicals.

DANGER – Ammunition Warning

Firearms may be damaged and serious personal injury or death to the shooter or bystanders may result from any

condition which contributes to the generation of excessive pressure or uncontrolled release of gas within the

firearm. Such adverse conditions can be caused by bore or chamber obstructions, propellant powder overloads or

by defective, incorrect or improperly loaded and assembled cartridge components. Even the strongest firearm can

be blown up as a result of excessive pr

essur

e. It is extremely dangerous to use a cartridge whose pressure is

greater than that developed by cartridges loaded to industry standards.