Product Manual

CHAIN SAW iNFORMATiON
CHAIN SAW HARDWARE
The plastic hardware bags should include the
lMlowing:
* (2) Guidebar bolts
* (2) Guidebar nuts
* (1) Phillips self tapping screw
. (1) Saw chain
* (1) Guide bar
* (1) Hand guard
* (1) Scabbard
CHAIN SAW ASSEMBLY
Assemble the chain saw before assembling the
pole.
Note: Some models are pre-assembled. Assembly
is not needed on these models.
See Stay gT_ainTension Adjustment, page I I.
WARNING: Cutting edges on chain
are sharp. Use protective gloves when
handling chain.
IMPORTANT: Do not clamp chain saw in
vise during assemNy.
Lay chain out fiat.
2. Install fi'ont hand guard onto saw body. Do this
by pressing two mounting stand-outs on hand
guard into hex-shaped holes in saw body (see
Figure 2). Towards Guide Bar Nose
Front Hand C__uard
Tapping
Screw
Guide Bar /+%.
Bolts
Mounting
Stand-OI
\ ................ )
_utting Edge
Saw
Bar
Hole
Guide Bar Nuts
Drive Sprocket
Figure 2 - Assembling Guide Bag Chain, and
Hand Guard
3 Insert tapping screw through hand guard and
into saw handle. Tighten screw firmly.
4. Turn adjusting screw counterclockwise (see
Figure 3). Continue to turn adjusting screw
until adjusting block is to rear of adjusting
plate.
5. Install guide bar onto saw body. Place rear of
guide bar between adjusting plate and sprocket
support.
10
IMPORTANT: Make sure to insert adjusting
block into oval adjusting hole on guide bar.
6. Line up holes on sprocket support with center
slot on guide bar and holes in saw body.
7. Insert guide bar bolts through fi'ont hand gum'd,
saw body, center slot of guide bar, and sprocket
support. Attach guide bar nuts to guide bar
bolts.
IMPORTANT: Tighten guide bar nuts finger
tight only. Make sure adjusting block is in oval
adjusting hole on guide bar.
8. Place chain around drive sprockeL then along
top groove of guide bar and around guide bar
nose. Note: Make sure cutting edges of chain
are facing the right direction. Position chain
so cutting edges on top of guide bar face guide
bar nose (see Figure 2).
9. Adjust saw chain tension. Follow steps under
Saw Chain Tension Adjustment, page 11.
_ CAUTION: Do not place chain on saw
backwards. If chain is backwards, saw will
vibrate badly and will not cut.
Adjusting
Adjusting Bloc k _late
Screw
Sprocket Support
Figure 3 - Part Locations For Assembling Guide
Bar