Product Manual

TROUBLESHOOTING

Note: For additional help, visit www.remingtonpowertools.com.

WARNING: Unplug chain saw from power source before servicing. Se-

vere injury or death could occur from electrical shock or body contact with

moving chain.

OBSERVED FAULT POSSIBLE CAUSE REMEDY

Saw runs, but does not cut Chain assembled backwaMs See Chain 3'aw A<v_'mb/y, page 10

on guide bar

Saw does not cut unless heavily Chain is dull See Shawening 5'awChain, page 20

forced. Cutting produces only

sawdust with few large chips

Saw runs slow. Saw stalls Low powersupplyvoltage Extensioncordwiresizetoosmall. See

easily Exr_,nsion CoMs, page 12

1. Press in trigger lockout before

squeezing trigger

2. Check cord connections

3. Check line fuse or circuit breaker

4. See authorized service center

5. See authorized service center

Motor of saw does not run

when you squeeze trigger

1. Trigger lockout not pressed

in to release trigger

2. Extension cord connections loose

3. Open line fuse or circuit breaker

4. Worn out motor brushes

5. Open wiring circuit on saw

Motor of saw runs, but chain Drive Sprocket Failure Remove and Inspect Drive Sprocket

does not move for damage

Chain does not get oil 1. Clogged oil slot in guide bar 1. Remove guide bar and clean oil

2. Oil is too thick slot

2. Use correct weight of oil. See

Filling Oi! Tank, page 12

Chain coines off guide bar 1. Chain is loose 1. Tighten chain. See Saw Chain Tg,n-

sion Ac!jusm_enr, page 11

2. Guide bar and chain not 2. See Chain 5'aw Assembly, page 10

assembled correctly

Saw smokes Saw damaged. Do not use saw See authorized service center

Saw leaks oil It is normal for oil to seep Note: Empty oil tank when not in use

when the saw is not in use.

REPAIR SERVICE

Note: Only use original replacement parts. This will protect your warranty coverage for parts

replaced under warranty.

For service, please call the Customer Support Department to obtain a list of authorized service

dealers near you. Seiwice on this unit, both within and alter the warranty period, should only be

perfbrmed by an authorized and approved service dealer.

Call 1-866-206-2707 (in Canada call 1-877-696-5533) or visit www.remingtonpowertools.coln.