Use And Care Manual

CLEANING AND STORAGE

CLEANING

1. Loosen the saw chain if the chain tension was adjusted during

operation. The saw chain will contract as the unit cools, which

could damage the unit if the chain is too tight.

2. Clean the unit with a damp cloth.

NOTE: When preparing the unit for long-term storage (30 days or

more), remove the guide bar and saw chain. Carefully clean the

guide bar cover, guide bar mounting surface and sprocket. Use

a firm non-wire brush to clean the guide bar groove.

Reassemble the unit.

3. Wipe off any moisture with a soft cloth.

4. Lightly coat the guide bar and saw chain with a corrosion-

inhibiting oil.

STORAGE

• Loosen the saw chain if the chain tension was adjusted during

operation. The saw chain will contract as the unit cools, which

could damage the unit if the chain is too tight.

• Allow the unit to cool.

• Thoroughly clean the unit and inspect it for any loose or

damaged parts. Repair or replace damaged parts and tighten

loose screws, nuts or bolts.

• Cover the guide bar and saw chain with the scabbard.

• Lock up the unit to prevent unauthorized use or damage.

• Store the unit in a dry, well-ventilated area.

• Store the unit out of the reach of children.

NOTE: It is normal for bar and chain oil to seep from the unit when

not in use. Please take this into consideration when storing the

unit.

WARNING:

To prevent serious injury, never clean the

unit while it is running. Always disconnect the unit from the

power source to prevent the unit from starting accidentally.

Always allow the unit to cool before cleaning the unit.

WARNING:

To prevent serious injury, do not douse the

unit with water. Do not submerge the unit in water or any

other liquid. Do not use strong detergents. Household

cleaners that contain aromatic oils such as pine and lemon,

and solvents such as kerosene, can damage plastic.