Full Product Manual

15
Device protection systems have engaged
Remove the battery, allow it to cool for 30 seconds, then reinstall
the battery
The battery charger is not plugged in Plug the battery charger into a 120V 60hz AC source
The battery is not fully inserted into the battery charger
Remove and then reinsert the battery into the battery charger
completely
T
he battery and/or charger are too hot or too cold
Make sure the battery and charger are in an environment between
3
2° and 104° F (0° and 40° C). Allow time for the battery and/or
charger to warm up or cool down.
The battery and/or battery charger are no longer functional Refer to the Warranty section for replacement information
TROUBLESHOOTING
The battery lacks sufficient charge Charge the battery completely
The battery is not installed correctly Remove and reinstall the battery
PROBLEM SOLUTION
The battery is not fully charged Charge the battery completely
The battery and/or battery charger are no longer functional Refer to the Warranty section for replacement information
If further assistance is required, contact an authorized service center.
THE BATTERY WILL NOT CHARGE
THE BATTERY DIES QUICKLY
THE MOTOR WILL NOT RUN
THE MOTOR STOPS WHILE IN USE, BUT THE BATTERY STILL HAS SUFFICIENT CHARGE