Full Product Manual

CAUTION:

If the saw chain was tensioned while warm, it

may become too tight when cooled. Loosen the chain

tension after operation and check the chain tension before

the next use.

Fig. 40

Fig. 41

Chain-Tensioning

Ring

Loosen

Tighten

Fig. 39

Bar Knob

Loosen

Tighten

Bar Cover

NOTE: A new saw chain tends to stretch and will need readjustment

after as few as five (5) cuts. This is normal during the break-in

period. The interval between future adjustments will lengthen

quickly.

1. Turn the bar knob counterclockwise to slightly loosen the bar

cover (Fig. 39). DO NOT remove the bar cover.

2. Hold the guide bar tip up (Fig. 40) and turn the chain-tensioning

ring to adjust the tension (Fig. 41).

• Turn the chain-tensioning ring clockwise to tighten the saw chain.

•

Turn the chain-tensioning ring counterclockwise to loosen the

saw chain.

he saw chain should fit snuggly against the underside of the

guide bar. There should be no sag (Fig. 42).

3. Continue to hold the guide bar tip up (Fig. 40). Turn the bar knob

clockwise to securely tighten the bar cover (Fig. 39).

Fig. 42

Incorrect Tension

Correct Tension