Manualshelf

Full Product Manual

ManualsBrandsRemington ManualsChainsaws12 in. 40-Volt Lithium-Ion Cordless Chainsaw 4.0 Ah Battery and Charger Included
21222324252627282930
The battery is not fully charged Charge the battery completely
The battery and/or battery charger are no longer functional Refer to the Warranty section for replacement information
The battery charger is not plugged in Plug the battery charger into a 120V 60hz AC source
The battery is not fully inserted into the battery charger
R
emove and then reinsert the battery into the battery charger
completely
The battery and/or charger are too hot or too cold
Make sure the battery and charger are in an environment between
32° and 104° F (0° and 40° C). Allow time for the battery and/or
charger to warm up or cool down.
T
he battery and/or battery charger are no longer functional Refer to the Warranty section for replacement information
The battery lacks sufficient charge Charge the battery completely
The battery is not installed correctly Remove and reinstall the battery
The trigger lockout was not engaged Press and hold the trigger lockout before squeezing the trigger
Device protection systems have engaged
Remove the battery, allow it to cool for 30 seconds, then reinstall
the battery
28
The saw chain tension is too loose Adjust the saw chain tension
The guide bar and saw chain are assembled incorrectly Refer to Removing and Installing the Guide Bar and Saw Chain
The saw chain tension is too tight Adjust the saw chain tension
The saw chain and guide bar lack sufficient oil Fill the chain oil reservoir
The guide bar groove and oil passages are dirty Clean the guide bar and oil passages
The saw chain tension is too tight Adjust the saw chain tension
The guide bar and saw chain are assembled incorrectly Refer to Removing and Installing the Guide Bar and Saw Chain
The guide bar and saw chain are damaged
Inspect the guide bar and saw chain for damage. Replace them if
necessary
The drive assembly is damaged Refer to Service information
The saw chain is dull Sharpen or replace the saw chain
The saw chain is on backwards Check and correct the saw chain direction
TROUBLESHOOTING
If further assistance is required, contact an authorized service center.
THE SAW CHAIN ROTATES, BUT DOES NOT CUT
THE SAW CHAIN DOES NOT ROTATE
THE GUIDE BAR AND SAW CHAIN ARE RUNNING HOT, SMOKING OR STUCK
THE SAW CHAIN COMES OFF THE GUIDE BAR
PROBLEM SOLUTION
THE BATTERY WILL NOT CHARGE
T
HE BATTERY DIES QUICKLY
THE MOTOR STOPS WHILE IN USE, BUT THE BATTERY STILL HAS SUFFICIENT CHARGE
THE MOTOR WILL NOT RUN