WETech CLOSE SHAVE USE & CARE MANUAL PLEASE READ PRIOR TO USE To register your product go to remington-products.com.au remington.co.
IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances, basic precautions should always be observed, including the following. READ ALL INSTRUCTIONS BEFORE USING For additional protection, the installation of a residual current device (rcd) having a rated residual operating current not exceeding 30 mA is advisable in the electrical circuit supplying the bathroom. Ask your installer for advice.
• For use on facial hair only. Not intended for shaving the hair on your head. • Do not plug or unplug the appliance with wet hands. • For household use only. • Do not place or store the appliance or charging adaptor where it can fall or be knocked into a sink or bath. • Do not place in or drop into water or any other liquid for extended periods of time. • If an appliance falls into water, “unplug it” immediately. Do not reach into the water.
XR1550AU WETech CLOSE SHAVE USE & CARE INSTRUCTION MANUAL Thank you for purchasing your new Remington® WETech CLOSE SHAVE rotary shaver. Inside this manual you will find tips on using and caring for your shaver. 3 2 4 5 1 6 7 KEY PARTS 1. 2. 3. 4. 5. 6. 7.
FEATURE XR1550AU Power System Cordless Initial Charge Time 24 Hours Full Charge Time 90 Minutes Cordless Shave Time 60 Minutes Quick Charge Yes Indicators LED Voltage Type Worldwide Charging Stand Yes Replacement Head & Cutters Part No. SPR-XR1550AU Power System: Cordless – shaver can only be used without the power cord. The shaver will not run while it is charging on its charging stand. Quick Charge: 5 minute charge supplies enough power for one shave.
CHARGING 1. Plug the power adaptor into the charging stand. (Diagram A) 2. Plug the power adaptor into wall outlet. (Diagram B) 3. Charge shaver for 24 hours before its first use. This first charge is important to the shaver’s battery life. (Diagram C) NOTE: During initial charge ignore the electronic indicators as they are in “start up cycle”. 4. Use shaver until recharge is required. A B C CAUTION: • Make sure the shaver and your hands are dry when charging the shaver.
SHAVING TIPS • The Remington® WETech CLOSE SHAVE is waterproof. You may use shaving foam or gel with your shaver. You may also shave in the shower. • Wait at least 15 minutes after getting up before shaving, to ensure your face is free of puffiness that may be present from sleeping. • Always hold the shaver at a right angle to the skin so that all three heads are touching the skin with equal pressure.
Spectrum Brands Australia Pty Ltd Locked Bag 3004 Braeside, VIC 3195 Australia SP5 Face Saver: Pre-shave Powder Stick Remington is a Registered Trademark of Spectrum Brands, Inc., or one of its subsidiaries. SP4 Shaver Saver: Aerosol Spray Cleaner $11.95 AUD $11.95 AUD $49.95 AUD Replacement Shaving Head & Cutters for XR1550AU SPR-XR1550AU Price each AUD Article $ $ 7.50 TOTAL $ $ $ $ Amount Sub Total Qty Postage & handling $14.95 NZD $14.95 NZD $54.
CLEANING & MAINTENANCE The shaver is a washable appliance. The head and body may be cleaned under warm water. NOTE: When cleaning your shaver, make sure the shaver is turned off and disconnected from the power cord. CAUTION: • When cleaning the external surfaces of the shaver, do not use strong detergents or other chemicals. • To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer or heater to dry the shaver.
Weekly Cleaning: 1. Locate the detachment grooves on the head & cutter assembly. Gently pull to detach the hair pocket from the neck assembly. (Diagram L) 2. Tap out excess hair shavings 3. Slide the blue cutter support frame upwards towards the direction of the two cutters to release it from the assembly. (Diagram M) 4. Lift and remove the cutter support frame away from the cutters. 5. Remove the cutters. (Diagram N) 6.
REPLACING THE HEAD & CUTTERS Please refer to the FEATURE table on page 5 of this manual that lists the correct replacement part number for your shaver. It is very important to replace your head and cutters when necessary to ensure a close, comfortable shave without irritation. We recommend they be replaced every 12 months. Here are some signs of head and cutter wear, indicating that replacement is needed: • Irritation: As the heads get excessively worn you may experience some skin irritation.
Spectrum Brands Australia Pty Ltd and Spectrum Brands New Zealand Limited WARRANTY AGAINST DEFECTS In this warranty: Australian Consumer Law means the Australian consumer law set out in Schedule 2 to the Competition and Consumer Act 2010; CGA means the New Zealand Consumer Guarantees Act 1993; Goods means the product or equipment which was accompanied by this warranty and purchased in Australia or New Zealand, as the case may be; Manufacturer, We or us means: 1.
8. In order to claim under the warranty granted under clause 3 you must: (a) Retain this warranty with your receipt/proof of purchase; and (b) Return the Goods to us at the relevant address below or to the Supplier by prepaid freight within the Warranty Period accompanied with (i) the legible and unmodified original proof of purchase, which clearly indicates the name and address of the Supplier, the date and place of purchase, the product name or other product serial number and (ii) this warranty. 9.