Product Info

RemoteSolution Co. Ltd,
Remote Controller Unit
3/6 page
1. Code Entry Method
The function is set by inputting 5-digit CODE to Device for each manufacturer.
How to enter set-up Mode?
*Press and hold the setting key for 3 seconds until Red is changed to Green LED Æ Enter Setting Mode.
1.1. UR Setting (TV).
1.1.1. Enter Setting Mode.
1.1.2. When the 5-digit entered in the brand list is present in the DB, the green LED turns off after blinking
twice.
1.1.3. If invalid Digit input is entered, Red LED and Green LED are blinked one time in sequence and then
turned off.
1.2. When the UR setting is completed, TV Power, Vol+/-, Mute, Source key are sent in UR Code.
2. Auto-Search Method
This function searches DB of Device by [CH+] or [CH-] key in turn, finds the setting numbers of the device, and
sets remote.
2.1. Enter the setting mode.
2.2. Press [9][9][1] sequentially to turn off the Green LED after blinking twice.
2.3. Enter the [CH+] or [CH-] key.
2.3.1. 3-Frame Power Code is output by [CH +] or [CH -] key input.
2.4. If the desired code is searched, enter the [OK] key.
2.4.1. Save the searched code and exit the setting mode after Green LED blinking twice.
2.5. If there is no key input for 10 seconds before [OK] key is input, Red LED and Green LED are turned off
after blinking one time in sequence, leaving setting mode
3. RF Pairing
This function is to transmit the key data of the cable device through RF
3.1. Process
3.1.1. Enter the setting mode
3.1.2. If you press [MENU] key, Green LED blinks and enters Discovery mode.
3.1.3. Check the 3-digit validation code on the STB screen and enter it with the remote control.
3.1.4. If the pairing is completed normally with entered input, the Green LED turns off after blinking twice.
3.2. Sending Data
3.2.1. When the pairing is completed, all the key data related to STB transmit through RF.
3.2.2. TV key data transmit through IR.
4. RF Un-Pairing
This function is to cancel the pairing between the STB and the remote control.
4.1 Enter the setting mode.
4.2 If you press [9][8][7], Green LED will blink twice with un-pairing.