Manualshelf

Product Info

ManualsBrandsRemote Solution ManualsElectronicsREMOTE CONTROL UNIT
1234567
RemoteSolution Co. Ltd,
Remote Controller Unit
4/6 page
5. Battery Monitor
This function is to check battery status.
5.1 Enter the setting mode.
5.2 Press [9][9][9], and check the LED status.
5.2.1. If the Green LED blinks 4 times, battery status is excellent.
5.2.2. If the Green LED blinks 3 times, battery status is good.
5.2.3. If the Red LED blinks 2 times, battery status is low.
5.2.4. If the Red LED blinks 1 times, battery status is very low.(should be replace)
6. Low Battery Detection
This function blinks the Red LED 5 times, each time the key is pressed and released when the battery voltage is
below 2.4V.
7. Couch Function
This function is to stop the IR output to reduce the battery consumption when any key is pressed for 30 seconds
continuously.
8. IR Un-Pairing
This function is to switch the set TV key to the default state.
8.1. Enter the setting mode.
8.2. Press [9][8][6], and the Green LED blinks 2 times with IR Un-Pairing.
9. Version Out
This function outputs 4-digit version of the remote control through LED.
9.1. Enter setting mode.
9.2. Press [9][8][3], the Green LED blinks 2 times.
9.3. Press [1] and check Red LED blink count
9.4. Press [2] and check Red LED blink count
9.5. Press [3] and check Red LED blink count
9.6. Press [4] and check Red LED blink count.
9.7. Red LED and Green LED sequentially blink 1 time and turn off. Finally setting mode is exited.
9.8. Example,
9.8.1. Press [1], Red LED blink 1 time.
9.8.2. Press [2], Red LED blink 8 times
9.8.3. Press [3], Red LED blink 1 times
9.8.4. Press [4], Red LED blink 0 times
9.8.5. Then, Remote version is 1.8.1.0.
10. Device Volume Setting
This function switches the Vol +/-, Mute Key to TV volume control or STB volume control mode.
10.1. TV Volume Control Mode
10.1.1. Enter setting mode
10.1.2. Press [Vol+] key and Green LED blinks 2 times and it switch to TV Volume control mode.
10.2. STB Volume Control Mode(Default)
10.2.1.
Enter Setting Mode
10.2.2. Press [Vol-] key and Green LED blinks 2 times and it switch to STB Volume control mode.