User's Manual

- 26 -
Editing Function Names in the Palette Editor
If a function displayed on the Source Components Remote is not displayed in the function list on the
left hand side of the Palette Editor window, you can either RENAME an existing function or ADD a
new function to the list. Editing function names in the Palette Editor will only effect the Palette File you
are currently saving to (i.e. Making a change to a function under DENON DVD will only appear in
DENON DVD).
To Rename an Existing Function:
1) Right-click on the function to be renamed.
Choose from the drop-down menu.
Edit the text as desired and press ENTER on your keyboard to save.
To Add a New Function:
Right-click on a blank area of the list and select from the drop-down menu.
Enter the name of the new function as you would like it to appear in the list and press ENTER
on your keyboard to save.
Testing IR Commands in the Palette Editor
1) Be sure corresponding source for the commands to be tested is ON and connected to the
XTR39.
2) Direct the XTR39 towards the source (IR eye).
3) With the PC still connected to the XTR39’s programming port, select in the Palette
Editor window.
The TEST button text will highlight .
4) Click on each of the command names one-by-one that need to be tested. The red light to the
left of “TEST” will turn on as the IR command executes.
5) The controlled component should respond to each command sent.(i.e. “Power” turns the
source ON or OFF, “PLAY” plays the content etc.)
NOTE: Only functions with the
symbol will execute.
6) If a component does not respond to a command, re-learn and re-test the IR command until the
component responds.
7) Repeat steps 1 thru 6 for all commands to be tested.