* The sensor detects open/close state of a door/window and + Hughes & RF front-end module are mounted on the sensor for distant operation up to tetrameters. + The sensor uses CR2032 col cell battery. 5 Battery lifetime is approx. 2 years. g + User can easily install using double sided tape. 2 + Please use screws as optional to tighten between door/ = window and a sensor. Door / Window = Keep the glued side of tape clean before installing a sensor. Sensor { This product is working with Ethernet gateway.
Caution : Metallic door/window can reduce operating signal power. it can affect on operating distance, The sensor installation is on the door frame. The magnet is on the door. Installation Guide 1 Sensor Module double sided tape hel le ee) + Gap Range Typ 10 mm (0.387 + Face arrows each other when install sensor Keep distance between sensor and magnetic module. 1 Se unscrew pl ABSCESS. Replace battery with arrow direction. Ig ns install on wall, door or window The sensor installation the left of the magnet.
Introduction Pairing 1. Press pairing button on the gateway. 2.The orange LED will blink then Tem perpetuate re the gateway turn Into the paring Sen SOF standby mods, {The orange LED will keep blink -ing for seconds) Document Number : Rev. 1.0 + Temperature sensor can be installed indoor such as house, office especially warehouse, bathroom and laundry room. + The sensor can measure temperature and send temperature data to Ethernet gateway via RF communication.
coc specifications Attach 1 double sided tape Install on wall 2 Open Top case unscrew screw, {see arrow) Replace Battery change How to fix using screws & Dimensions L= 28mm, W= 545mm, H= 11 3mm Power source CR2032(3V) Lithium Battery lea Battery Lifetime yesteryear 25°C (77 TF), typical, Indoor use Operating Temperature 0°C ~50°C, Indoor use Reporting range (Temperature) Accuracy £2°C Storage Temperature 0c ~80C Relative Humidity up to 95% non-condensing AF Performance Requirements — Protocols : Zambezi HA
Pairing button Press pairing button on the gateway. Pairing 2.The orange LED will blink then the gateway tum Into the pairing standby mode, {The orange LED will keep blink -ing for seconds) Humidity Sensor Document Number : Rev. 1.0 + Humidity sensor can be installed indoor. Such as house, office, warehouse etc, + The sensor measures humidity and reports humidity data to Ethernet gateway via RF communication. + Low voltage communication and embedded RF amplifier provide a wide range of communication.
1 Attach double sided tape Installation Guide 1 2 Install on wall Open Top case unscrew a screw, (see arrow) 2 Replace battery with arrow direction.