User's Manual
Press Pairing button
on the sensors once.
Pairing
button
CR2032 Coin cell (1ea)
Metal Pairing Pin
(1ea)
1. The sensors retry to pair with a
red color LED blinking.
2. The method of the registration as
pairing is done.(Should check the
list on the smart phone.)
·User can edit the text regarding
registered sensors on DSR application.
The gateway and the sensor will try
pairing for 40seconds.
If they are failed to be paired within
40seconds, the orange LED will be o.
3. Pull battery tab from the sensor
to try pairing with the gateway.
(The sensor will try pairing for 40seconds.)
4.
Once orange LED is o, pairing is done.
1. Press pairing button on the
gateway.
2. The orange LED will blink then
the gateway turn into the pairing
standby mode.
(The orange LED will keep blink
-ing for 60seconds.)
Please refer to this when changing the battery or using screws.
·Sensor is designed to try pairing
when pull tab is initially removed
Pairing
failure
Pairing
button
!
Please follow below instruction in
case pairing is failed.
( This product is working
with ethernet gateway. )
Pairing Guide
Document Number : Rev. 1.0
Introduction
Package Contents
Bottom cover
Top case
Screw B (2ea)
Double sided tape
Battery holder
Option
Screw A (2ea)
Wireless
Movement
Sensor
·Movement sensor can report the gateway via radio
communications door/window state, open or close by
recognizing door movement.
·Low voltage communication and embedded RF amplier
can provide a wide range of communication.
·The sensor uses CR2032 coin cell battery.
Battery lifetime is apporx. 5years.
·In case of damage, sensor can detects damage and notify
Ethernet gateway.
·User can easily install using double sided tape.