User's Manual

TheaterTouch System Controller

HOW TO EDIT AN IR COMMAND IN A MACRO

To edit an individual command in a macro you must have the macro

displayed in the Macro Editor.

Double click on the command in the macro you want to edit to open the

Edit Infrared Command

dialog box.

Note:

Not all of the controls will be available simultaneously. Only the options

relevant to the default settings and command being edited will be shown.

The

Edit Infrared Command

options are:

Minimum Repeats -

Enter in this box the number of times that the repeating

part of the IR code is sent by the remote. Some infrared receivers need a

command to be repeated a certain number of times to work properly, and

some may not work properly if the command is repeated at all. Even if a

command works properly, increasing the number of repeat times may be

necessary if the command is to be used in a macro. Since macro commands

are not automatically sustained while a button is pressed, they may need to

automatically repeat more times to be recognized.

Frequency –

Shown in this box is the carrier frequency of the IR code, this is

set automatically. You should not need to change this value unless directed to

do so by Technical Support.

Repeat while button is pressed -

Check this box to cause this IR code to be

repeated for as long as the button is held down.

Note:

Only one command in any macro can have this property set.

Output Type:

Unless the system contains a mixture of direct IR and IRF-6/RF commands,

this option will not normally need to be changed.