User's Manual
Universal System Controller
T2-Cs
12
CLEANING
Occasional cleaning may be required, depending on use. It is
recommended that you create a “Clean” button somewhere on the Home
page of the T2-Cs. This button should link to a page that does not contain
commands or macros that could be inadvertently executed while cleaning
the unit. The “Clean” page could contain a text message or graphic of your
choosing such as:
To clean your T2-Cs, lightly dampen a lint-free cloth with a glass cleaner or
mild detergent, and wipe the touchscreen, keypad and outer surfaces.
BATTERY AND DOCKING STATION
The T2-Cs uses a Lithium-Ion rechargeable battery. This battery does
not exhibit any type of “Memory Effect” from being charged too often.
Since the T2-Cs can safely be charged after each use, a docking station is
included for convenience. If left out of the docking station, the T2-Cs will
remain in sleep mode for 1 – 2 months before shutting down. At that point
the battery must be recharged.
The T2-Cs Docking Station can be placed on a at surface such as a shelf
or table, or it can be mounted to a wall using the mounting holes on the
back of the unit.
If the T2-Cs battery capacity is reduced to approximately
25 percent, a low battery icon will appear in the top center
of the display.
The low battery icon will change color to red if the battery
capacity becomes critically low. At this point the T2-Cs
must be placed into the docking station to recharge the
battery.
The docking station LED illuminates red to indicate a charge in progress.
The LED will illuminate blue when the battery in the unit is fully charged
or does not need to be charged. A fully discharged battery will take
approximately 2-4 hours to completely re-charge. The T2-Cs can remain in
the docking station indenitely without damage to the battery.
CHAPTER 2 | INTRODUCTION