User's Manual

Reset ZXT-120 to factory default
Press and hold "PROG" button for 10 seconds on ZXT-120. During the key hold period,
RED LED lights up at around 5 seconds, then, it will flash twice until reset process is
completed at around 10 seconds.
ZXT-120 Information
How to get the NIF "Node Information Frame" on ZXT-120 (Inclusion)?
- This reset step will not affect the listening mode of ZXT-120, user should refer to
"Listening Mode" section if you want to change the listening mode.
- If you are using Gateway or other Z-wave controllers to operate ZXT-120, please
follow the instruction from the gateway or other controller.
Information
14
Press the PROG button on the ZXT-120
Setup Key
LED Indication Status
on ZXT-120
- LED flashes once then stay off.
(ZXT-120 will report the supported
command class)