User's Manual

7
How to switch ZXT-120 listening mode from "Always Listening" to
"FLiRS" (or vice verse)
Inclusion/Exclusion
The primary controller should indicate that the action was successful. If the controller
indicates the action was unsuccessful, please repeat the procedure.
Step
1
Press and hold the PROG button on
the ZXT-120 for around 5 seconds
Setup Key
LED Indication Status on ZXT-120
- LED turns ON after PROG key
hold for 5seconds
2
Release the button and then press the
PROG button 3 times within 2 seconds
- LED flashes twice then stay off
(ZXT-120 set in FLiRS mode)
OR
- LED flashes four times then stay
off (ZXT-120 set in Always
Listening mode)
Step
1
Refer to your primary controller
instructions to process the inclusion/
exclusion setup procedure.
Setup Key
LED Indication Status on ZXT-120
2
When prompted by your primary
controller, click once on the PROG
button
- LED flashes once then stay off
(ZXT-120 will report the
supported command class)