User's Manual

46
⇓
3
Select “Create a Sec.”
then press
key.
4
Please make sure the
target secondary
controller is setup to
receive information
mode.
(e.g. target secondary
controller should entry
the “Learning mode＂
if this is a another ZRC-
100. Please refer to the
target controller user
manual for more
information)
=> Target secondary
controller will become a
secondary
controller
after this action.
=> Original ZRC-100
primary controller will
still keep in a primary
controller after this
action.
⇓
Create a Primary Controller
(Transferring Only Network Information to a New Primary Controller)
You can just transfer network information to another remote so that it
will become the new primary remote. This primary shift
is done by
following the steps below.
Create a Sec.
Copying…
>>>>
Create a Sec.
Copying…
>>>>
OK
Network Setup
Rediscover N.W. >
Delete Dead Node >
OK to Enter
Re-scan Devices >
Network Setup
Listenin
g
Mode >
OK to Enter
Create a Sec. >
Create a Pri >