User's Manual

9
2
Select “Add Device＂.
3
Press
key to add
the device into Z-Wave
network.
4
Press the program button
on the target device.
⇓
Note 1: If you can’t add your Z-Wave device, this device might have
been included in another Z-Wave network. In this case, please delete
this device following the steps in the [Deleting Device from the
Network] section then add this device again.
Note 2: This step can be skipped if the device is already included in the
network.
Note 3: If no ACK signal received for more than 60 seconds, the “Add
Device” mode will exit automatically.
Add Device
Press PROG on tar
g
e
t
>>>>
Savin
g
Data …
Add Device
Press PROG on tar
g
e
t
>>>>
O
K
Add Device
Press PROG on tar
g
e
t
>>>>
Setup
Add Device >
Delete Device >
Add to Scene >
OK to Enter