User's Manual

Notes:

1. It is recommended to perform the Remove (Exclude) procedure before per-

forming an Add (Include) procedure.

2. Red Indicator ashes TWICE then stay off to represent the Add / Remove pro-

cess failed, please repeat the above step again.

3. If the Add (Include) process fails, try Remove (Exclude) and /or resetting the

AC Master to Factory Default and repeat the above step.

Step 3 Setup Automatic Status Report Association to Gateway

Step 4 Setup Air Conditioner IR code

• The UI of set up the IR code varies from dierent gateways. If gate-

ways have dedicated UI for the IR code setup please refer to the

gateway UI and ignore the below steps.

• If your gateway does not have dedicated UI for ZXT-600 IR code

setup, but support Z-Wave thermostat Command Class and Con-

guration Command Class. You may refer to below steps to setup

the IR code using the conguration options in your gateway

ZXT-600 supports 1 association group

Association Group #1

Association Group #1 (max. 1 node) is default to associate with the

primary controller (Gateway/Hub/Controller) for AC Master Status

change report, refer to below for report details:

• Current Room Temperature (report in precision of 0.5°C or 1°F) (It

will be according to Conguration Parameter 39 setting to decide

the trigger level)

• Current Battery Level (Only apply in Low Battery Warning hap-

pened)

• Device Reset Locally Notication (Only report when the AC Master

has been triggered the RESET TO DEFAULT)