Use and Care Manual

OWNER’S MANUAL | RENANIM ADJUSTABLE BED | MODEL: SerenityFlex
You may contact us at: [e-mail]. | [phone] 7
INSTALLATION GUIDE
SETTING UP YOUR ADJUSTABLE BED
7
Install mattress retainer bars by inserting both
ends of it into the hole on the platform and lay the
bars down with curved sides facing up.
Setup is now complete!
6
To ensure a successful pairing process, please ensure that both the base and the remote have
power. Once the batteries are installed, follow the steps below to complete the pairing process:
Matching code:
1. Simultaneously press the head up and foot up buttons on the remote control. Be sure to hold them
down without releasing them.
2. While holding both buttons, locate the small button on the side of the control box or the button on
the extension wire of the motor [please refer to the picture below where to find the buttons].
3. Press the small button while holding down the head up and foot up buttons on the remote control.
4. Hold down the buttons until you hear a warning tone or a "didi" sound. This sound indicates that the
pairing process is successful.
Note: For Split King adjustable bed users:
(a) You may use one remote to operate two-bed bases.
- Follow the steps above while only using one remote to pair both beds.
(b) If you want to use the beds separately, please follow the instructions above to pair the first set of beds
and the remote. Then, proceed to pair the second set.
Note: Kindly ensure that you follow the steps. If it does not work, unplug the beds to reset the electrical
components for an hour or more, then try again.