Handbook

1.15
ENG_UD10781_1
Appuis-tête avant (X95 - J95 - R95 - Renault)ENG_NU_840-2_JR95_Renault_1
To raise the headrest
Pull the headrest upwards to the de-
sired height.
To lower the headrest
Press button 2 and guide the headrest
down to the desired height.
To adjust the angle of the
headrest
Depending on the vehicle, move sec-
tion A towards or away from you to the
required position.
To remove the headrest
Fit it in its highest position, press
button 1
on each rod 3 and lift to re-
lease.
Note: when the headrest is removed,
take care not to change the positions
of rods
3.
To refit the headrest
If the setting of rods 3 has been altered,
pull them fully upwards. Take care to
ensure they are clean and correctly
aligned and, if there are any problems,
check that the notches are facing for-
wards.
Insert the headrest rods into the holes
(tilt the seatback backwards if neces-
sary).
Lower the headrest until it locks, press
b
utton 1
on each rod 3 and lower the
headrest as far as possible.
To adjust side supports B
Depending on the vehicle, sections B
can be adjusted independently to the
desired position.
FRONT HEADRESTS
The headrest is an impor-
tant safety component:
ensure that it is in place and
in the correct position. The
distance between your head and the
headrest and the distance between
t
he head and section A should be
as small as possible.
B
A
2
3
B
1