Specifications

ENGLISH
5
High-Level Inputs (HI INPUT)
This amplifier can be connected with the
speaker outputs of any head unit .
Input Connections & Functions
Low Level RCA Cinch Inputs (INPUT)
This amplifier can be connected to any car stereo or
head unit with low level RCA Cinch outputs.
Bass EQ:
The Bass-Boost-Switch ”BASS EQ” elevates the lower bass ranges. The desired elevation can be
set on the ”BASS EQ” switch (0 dB / + 6 dB / + 12 dB).
Lowpass-Filters with adjustable crossover frequency
If the amplifier is used as subwoofer amplifier, set the switch ”X-OVER” to ”LP”. Then set the desired
X-Over frequency with the control ”LOWPASS”.
Highpass-Filters with adjustable crossover frequency
If the amplifiers is to be used for satellite loudspeaker (mid-range/tweeter) amplification, set switch
”X-OVER” to ”HP”. Set the desired X-Over frequency with the control ”HIGHPASS” and only the
frequencies above the set will be amplified.
REN 550 S
REN 1100 S
CAUTION:
Do not wire high and low inputs at the same time. This will result in damage to
the amplifier and other units in the set up.
Low Level RCA Cinch Outputs (OUTPUT)
Use this line output to send the fullrange audio signal to another amplifier.
Low Level RCA Cinch Outputs (OUTPUT)
Use this line output to send the fullrange audio
signal to another amplifier.
Low Level RCA Cinch Inputs (INPUT)
This amplifier can be connected to any car stereo
or head unit with low level RCA Cinch outputs.
REN 550 S/REN 1100 S
L
R
OUTPUTINPUT
HI INPUT
+--+
BASS EQ X-OVER
LEVEL
LOW
PASS
HIGH
PASS
Min Max 50Hz 250Hz 80Hz 2kHz
0
6
12 FULL HP
LP
L R
ADJUST PANEL
L
L
R R
OUTPUT INPUTINPUT FRONT
REAR
X-OVER
FULL HP
LP
X-OVER
FULL HP
BASS EQ
0
6
12
LOW
PASS
50Hz 250Hz
HIGH
PASS
80Hz 2kHz
HIGH
PASS
80Hz 2kHz
LEVEL
Min Max
LEVEL
Min Max
POWER
PROTECT