User`s manual

AUDIO SIGNAL CABLES

WheninstallingtheaudiocablesbetweentheRCAoutputsoftheheadunitandtheRCAinputsoftheamplier,

the audio and power supply cables should, if possible, not be routed along the same side of the vehicle. We

recommend a separated installation, e.g. routing the power cable through the cable channel on the left side

and the audio cables through the cable channel of the vehicle on the right side or vice versa. This prevents

interferences due to crosstalk into the audio signal.

SIGNAL OUTPUTS TO CONNECT ADDITIONAL AMPLIFIERS

The input signal on the INPUT jacks (Fig. 1,8) will be routed in stereo to the output jacks OUTPUT (Fig. 1,7).

ThustheOUTPUTjackallowstheconnectionofaadditionalamplier.

INPUT SENSITIVITY

OPERATING ELEMENTS

TurntheLEVEL(Fig.1,6)controlleroftheampliertotheMINposition.Thenturnthevolumecontrollerofthe

headunit to 80 - 90% of its full setting. Now turn LEVEL clockwise until you hear some distortion. Then turn back

the LEVEL slightly until you hear a cleaner sound.

VARIABLE SUBSONIC FILTER

WiththeSUBSONICcontroller(Fig.1,4)youcanadjustthelowercross-overfrequency,toltertheverylow

frequencies to relieve the subwoofer or to generate a bandpass signal. If you don’t want to use this function,

turn the controller (Fig. 1,4) to the very left to the 15 Hz position.

NOTE: The adjusted value of the SUB SONIC (Fig. 1,4) should not be higher than the adjusted value of the

LOW PASS controller (Fig. 1,5). Otherwise no sound will be hearable.

PROTECTION CIRCUIT

ThePOWER-LED(Fig.1,1)litsup,iftheamplierisinoperation.

ThePROTECT-LED(Fig.1,1)litsup,whentheamplierisoverheated,orashortcircuitoccursresp.atoolow

impedance load is connected to the speaker outputs. If this events, the internal built-in protection circuit shuts

downtheamplierautomatically.Theampliershouldworkagainproperlyafteryouhavesolvedtheproblems.

VARIABLE LOW PASS FILTER

Set the desired cross-over frequency by using the controller (Fig. 1,5). Thus to that only the frequencies below

thechosencross-overfrequencywillbeampliedandthesubwooferplaysmoreprecisedandefcient.

BASS LEVEL REMOTE CONTROLLER

With the included bass level cable remote controller you are able to adjust the bass level e.g. out of the driver’s

seat.

VARIABLE BASS EQ

With the bass boost controller (Fig.1,3) you are able to adjust the bass level from 0 - 12 dB at 45 Hz.

Attention: Use the BASS EQ wisely!