User`s manual

11
FIGURES (P. 28-30)
CONNECTIONS AND CONTROLLERS (FIG. 1)
(1) POWER-LED and PROTECT-LED
(2) Connector for the included bass level remote controller
(3) Bass EQ controller
(4) Subsonicltercontroller
(5) Lowpassltercontroller
(6) Gain evel controller
(7) Audiosignaloutputstorunadditionalampliers
(8) Audio signal inputs
POWER SUPPLY AND TURN ON CONNECTION (FIG. 2)
(1) GND terminal for the ground
(2) REM terminal for the turn on connection
(3) +12 V terminal for the positive-connection of the battery
(4) Vehicle’s battery
(5) In-Line Fuse (not included in the scope of delivery)
(6) Turn on wire from the headunit or the electrical antenna
(7) Fuse
1-CHANNEL OPERATION MONO 2 SUBWOOFERS (FIG. 4)
Ifyou want to runtheamplier with the 2line output channels fromtheheadunit to drive twosubwoofers,
connect the following setup:
(1) To the headunit, line output rear left or subwoofer output
(2) To the headunit, line output rear right or subwoofer output
(3) Bass level remote controller
(4)Subwoofer1(4-8Ω)
(5) Subwoofer2(4-8Ω)
1-CHANNEL OPERATION MONO 1 SUBWOOFER (FIG. 3)
Ifyouwanttoruntheamplierwiththe2lineoutputchannelsfromtheheadunittodriveasubwoofer,connect
the following setup:
(1) To the headunit, line output left or subwoofer output
(2) To the headunit, line output right or subwoofer output
(3) Bass level remote controller
(4)Subwoofer(2-8Ω)
IMPORTANT!
Always observe the correct polarity of all connections!