4500/720 Series 720 Family Models 4513, 4514 Group User's Manual

APPLICATION
2.4 Serial I/O
2-46
4513/4514 Group User’s Manual
Fig. 2.4.5 Master serial I/O setting example
g0 h
b3 b0
➀ Disable Interrupts
Serial I/O interrupt is temporarily disabled.
Interrupt enable flag INTE
Interrupt control register V2
“0”
✕✕
All interrupts disabled (DI instruction)
Serial I/O interrupt occurrence disabled
(TV2A instruction)
0
✕
➁ Set Serial I/O
Serial I/O mode register J1
b3 b0
1
1
✕
Internal clock selected (TJ1A instruction)
Serial I/O port selected
Dividing ratio = 4 selected
1
g0 h
➂ Clear Interrupt Request
Serial I/O interrupt activated condition is cleared.
Serial I/O transmit/receive
completion flag SIOF
“0”
Serial I/O interrupt activated condition cleared
(SNZSI instruction)
Note when the interrupt request is cleared
When ➂ is executed, considering the skip of the next instruction according to the
SIOF flag, insert the NOP instruction after the SNZSI instruction.
When interrupt is
not used
When interrupt is used
➃ Set Interrupt
Interrupts except serial I/O is enabled
(EI instruction)
➃ Set Interrupt
Serial I/O interrupt temporarily disabled is enabled.
b3 b0
1
✕✕✕
Interrupt control register V2
Serial I/O interrupt occurrence
enabled (TV2A instruction)
Interrupt enable flag INTE
“1”
All interrupts enabled
(EI instruction)
➄ Start Condition of Serial I/O operation
Slave side is enabled to receive is checked.
Pin level of control signal = “L”
➅ Start Serial I/O Operation
Serial transfer is started (SST instruction) after checking
slave side is enabled to receive.
➆ Check Serial I/O Interrupt Request
SIOF flag is checked (SNZSI instruction).
➆ Serial I/O Interrupt Occur
➇ Execute Receive Data
Data received by serial transfer is executed.
Register SI → register A, register B (TABSI instruction)
“✕”: it can be “0” or “1.”
When serial communication is executed, ➄ to ➇ are repeated.