4500/720 Series 720 Family Models 4513, 4514 Group User's Manual

1-56
HARDWARE
4513/4514 Group User’s Manual
Table 22 Key-on wakeup control register, pull-up control register, and interrupt control register
K03
K02
K01
K00
Key-on wakeup control register K0
PU03
PU02
PU01
PU00
Key-on wakeup not used
Key-on wakeup used
Key-on wakeup not used
Key-on wakeup used
Key-on wakeup not used
Key-on wakeup used
Key-on wakeup not used
Key-on wakeup used
Pins P12 and P13 key-on wakeup
control bit
Pins P10 and P11 key-on wakeup
control bit
Pins P02 and P03 key-on wakeup
control bit
Pins P00 and P01 key-on wakeup
control bit
at reset : 00002 at RAM back-up : state retained
0
1
0
1
0
1
0
1
Pull-up transistor OFF
Pull-up transistor ON
Pull-up transistor OFF
Pull-up transistor ON
Pull-up transistor OFF
Pull-up transistor ON
Pull-up transistor OFF
Pull-up transistor ON
Pins P12 and P13 pull-up transistor
control bit
Pins P10 and P11 pull-up transistor
control bit
Pins P02 and P03 pull-up transistor
control bit
Pins P00 and P01 pull-up transistor
control bit
R/W
Pull-up control register PU0 at reset : 00002 at RAM back-up : state retained
0
1
0
1
0
1
0
1
R/W
I13
I12
I11
I10
I23
I22
I21
I20
Not used
Interrupt valid waveform for INT0 pin/
return level selection bit (Note 2)
INT0 pin edge detection circuit control bit
INT0 pin
timer 1 control enable bit
This bit has no function, but read/write is enabled.
Falling waveform (“L” level of INT1 pin is recognized with the SNZI1
instruction)/“L” level
Rising waveform (“H” level of INT1 pin is recognized with the SNZI1
instruction)/“H” level
One-sided edge detected
Both edges detected
Disabled
Enabled
Not used
Interrupt valid waveform for INT1 pin/
return level selection bit (Note 3)
INT1 pin edge detection circuit control bit
INT1 pin
timer 3 control enable bit
Notes 1: “R” represents read enabled, and “W” represents write enabled.
2: When the contents of I1
2 is changed, the external interrupt request flag EXF0 may be set. Accordingly, clear EXF0 flag with the SNZ0 instruction.
3: When the contents of I2
2 is changed, the external interrupt request flag EXF1 may be set. Accordingly, clear EXF1 flag with the SNZ1 instruction.
Interrupt control register I1 R/Wat RAM back-up : state retainedat reset : 00002
This bit has no function, but read/write is enabled.
Falling waveform (“L” level of INT0 pin is recognized with the SNZI0
instruction)/“L” level
Rising waveform (“H” level of INT0 pin is recognized with the SNZI0
instruction)/“H” level
One-sided edge detected
Both edges detected
Disabled
Enabled
0
1
0
1
0
1
0
1
0
1
0
1
0
1
0
1
Interrupt control register I2 R/Wat RAM back-up : state retainedat reset : 00002
FUNCTION BLOCK OPERATIONS